Eiffage set to be concessionaire for France’s RCEA project

France’s Transport Ministry has chosen construction and concessions group Eiffage as the single prospective concessionaire for the project to complete the Route Centre-Europe Atlantique. The east-west RCEA is considered to be one of the most dangerous routes in France, according to government statistics. Some sections of the route, also called the Route Nationale 79, has been upgraded into a four-lane motorway over the past several decades. The plan is make the remaining two-lane sections into four-lanes
June 17, 2019 Read time: 2 mins
France’s Transport Ministry has chosen construction and concessions group 5871 Eiffage as the single prospective concessionaire for the project to complete the Route Centre-Europe Atlantique.


The east-west RCEA is considered to be one of the most dangerous routes in France, according to government statistics. Some sections of the route, also called the Route Nationale 79, has been upgraded into a four-lane motorway over the past several decades. The plan is make the remaining two-lane sections into four-lanes.

French media reported that negotiations will now begin to finalise the project that could cost as much as €600 million, according to an estimate made last year by Benoît de Ruffray, chief executive of Eiffage.

The concession – which will not be bolstered with any public money – must include the provision for  clean vehicles and the deployment of electric vehicle charging equipment.

The project must be finalised by France’s transport regulator ARAFER and then given the go-ahead by the State Council, likely by the end of the year.

Finance & Funding

For more information on companies in this article

Related Content

  • Researchers trial 3D printing for both concrete and asphalt roads
    February 27, 2019
    Automated road repairs, using 3D printing, could save money and vastly reduce disruption, and researchers are already showing it’s possible - Kristina Smith reports It’s the middle of the night, and in the street below a team is busy carrying out repairs to the road surface. But there isn’t a human in sight. A road repair drone has landed at the site of a crack and a 3D asphalt printer is now busy filling in that crack. A group of traffic cone drones have positioned themselves around the repair location
    Read More
  • Indian highways road construction
    April 16, 2012
    Superlatives, once applied only to China's phenomenal growth, are now being used for India. Patrick Smith reports Those involved with the Naini Bridge in Allahabad are so proud of the result that they have set up an exhibition centre detailing its construction.
    Read More
  • Road safety improvement across Europe
    June 18, 2021
    Road safety improvements vary across Europe.
    Read More
  • Warm asphalt is a hot topic
    June 12, 2012
    Lower temperature mixes – a key advance in bitumen technology - Kristina Smith reports Warm and cold mix asphalts were not on the original agenda for this year’s Eurasphalt & Eurobitume Congress, being held in Istanbul in June. But when the organisers took a look through the papers submitted for their sustainability-themed event, they realised that this is one of the industry’s hottest topics. “We hadn’t quite anticipated the high level of research in this area,” says E&E’s technical programme committee c
    Read More

Highlighted Content