Improved grader efficiency with Trimble technology

The introduction of the Earthworks for Motor Graders package offers a GNSS-based, 3D grade control system that makes fine grading more accurate, faster and easier. This utilises the same hardware as the firm’s existing excavator and dozer packages, with IMU units featuring inertial measurement technology fitted to key moving components on the machine. These provide three axis tracking of operations Scott Crozier, general manager for Trimble's Civil Engineering and Construction Division said, “It’s the thir
December 10, 2018 Read time: 2 mins
Trimble’s new package for graders will allow faster and more accurate grading operations

The introduction of the Earthworks for Motor Graders package offers a GNSS-based, 3D grade control system that makes fine grading more accurate, faster and easier. This utilises the same hardware as the firm’s existing excavator and dozer packages, with IMU units featuring inertial measurement technology fitted to key moving components on the machine. These provide three axis tracking of operations

Scott Crozier, general manager for 2122 Trimble's Civil Engineering and Construction Division said, “It’s the third key machine,” adding that the system is already available for excavators and dozers.

The system allows the operator to carry out precision grading even while the machine is running in third gear. This is said to offer a 15% boost in productivity over graders equipped with Trimble’s already highly accurate and efficient GCS900 package. The package also uses the same intuitive, easy-to-use and learn Trimble Earthworks software already available for excavators and dozers. In addition, Trimble says that contractors can take advantage of the increased hardware portability available across a fleet for a quicker return on their machine control investment.

Connected Construction

For more information on companies in this article

Related Content

  • Asphalt milling and paving with 3D control
    February 16, 2012
    Milling and paving repair operations for airport runways require particularly high tolerances, an obvious market for 3D control solutions writes Mike Woof. Airport runways require some of the most accurate quality standards and tightest tolerances of any asphalt or concrete surface. This is one area where the high precision capabilities of 3D systems offer clear advantages.
    Read More
  • Improved excavator models available
    September 7, 2021
    Improved excavator models are now being made available for customers wanting higher performance
    Read More
  • Surveying software from Trimble
    June 15, 2021
    Trimble has introduced its Siteworks SE Starter Edition, an entry-level, easy-to-use construction surveying software.
    Read More
  • New developments in bulldozers and graders
    February 7, 2017
    A number of new bulldozer and grader developments are now coming to market - Mike Woof reports Bulldozers and graders are often overlooked as earthmovers, with the focus all too often concentrating on excavators, wheeled loaders and ADTs. However, key manufacturers are rolling out new graders and bulldozers too, which are also benefiting from the latest low emissions engine technology as well as advanced telematics systems and improved cabs with better all-round visibility. Caterpillar’s 26tonne 14M3
    Read More

Highlighted Content