Faster patching and marking from Ennis Prismo

Ennis Prismo is introducing a new pothole reinstatement product called Repair as well as a temporary line marking system.
March 1, 2012 Read time: 1 min
1394 Ennis Prismo is introducing a new pothole reinstatement product called Repair as well as a temporary line marking system.

The pothole product, Repair, is said to be quick, easy and safe to use as well as being inexpensive to purchase. It requires little training to use and is said to be ready to carry traffic immediately after installation. It is also said to provide a permanent repair even on roads with high traffic volume.

Meanwhile, the temporary line marking system called Paintmark offers a solution to temporary delineation.

It requires no heat or heavy machinery to apply, is highly durable and can be removed by simply gently heating and peeling. The removal causes no damage and leaves no residue on the road surface.
Maintenance

For more information on companies in this article

Related Content

  • High-tech, high places: 3M in US and MetService in New Zealand
    August 1, 2017
    The US state of Michigan sets up a high-tech test road while New Zealand’s transport officials buy in some high-tech weather forecasting. The road safety division of 3M will provide the US state of Michigan with lane markings and retroreflective signs for a connected vehicle technologies trial along the I-75 highway. Around 5km of the Interstate 75 work zone in Oakland County will be transformed over the next four months to improve safety for drivers and test advanced vehicle-to-infrastructure technologie
    Read More
  • Simex unveils GEN II of ART 1000 asphalt regeneration tech
    March 6, 2025

    Simex has released the new GEN II version of its ART 1000 patented technology for in-situ regeneration of deteriorated asphalt.

    Simex ART technology focuses on surface-level interventions for the functional recovery of road deterioration. It does not require the removal of milled material or the addition of virgin bituminous mix, instead utilising only the existing on-site material. Most importantly, it avoids the complete interruption of vehicular traffic, ensuring the road is immediately passable after restoration.

    Read More
  • Airport runway rebuild at Bologna
    May 15, 2019
    Rebuilding a runway requires special attention to detail to maximise efficiency and safety Airport runways face special challenges with regard to the loads they carry on a daily basis, particularly when aircraft are landing. A modern jet aircraft will typically land at speeds of around 240-260km/h, with a laden 747 weighing as much as 265tonnes at the end of a long flight. The stresses these large aircraft place on runway surfaces are enormous and not just with the massive impact forces exerted during
    Read More
  • Clean wheel innovation
    February 6, 2012
    ITALIAN CONSTRUCTION equipment manufacturer, TowerLight, has established a special division that will focus on wheel-washing technology.
    Read More

Highlighted Content