Skip to main content

New alternative to batteries for EVs

A new development looks set to offer an efficient alternative to lithium ion batteries for use in electric vehicles (EVs). At present the current generation of EVs feature lithium-ion batteries to store energy. However the performance of the lithium ion batteries has been criticised, particularly with regard to the recharge time required as this is considerably longer than the time needed to refuel a combustion engine-powered vehicle. While faster charging technologies are available for lithium ion batterie
November 15, 2013 Read time: 3 mins
A new development looks set to offer an efficient alternative to lithium ion batteries for use in electric vehicles (EVs). At present the current generation of EVs feature lithium-ion batteries to store energy. However the performance of the lithium ion batteries has been criticised, particularly with regard to the recharge time required as this is considerably longer than the time needed to refuel a combustion engine-powered vehicle. While faster charging technologies are available for lithium ion batteries, these reduce battery life considerably. The charging time has been identified as a major reason for the slow adoption rate of EVs around the world. However a team of engineers is working on a novel solution by developing a graphene supercapacitor that can store almost as much charge as a lithium ion battery but charges in just 16 seconds.

This new capacitor is being developed at the Gwangju Institute of Science and Technology in South Korea. The team’s high-performance supercapacitors use graphene and are said to store almost as much energy as a lithium-ion battery. In terms of practicality, they can charge and discharge in seconds, and maintain 98% of their initial value after 10,000 cycles.

The project is using a highly porous form of graphene that has a very large internal surface area. This material is produced by reducing graphene oxide particles with hydrazine in water agitated with ultrasound. The graphene powder is then packed into a coin-shaped cell, a pressure of 300kg/cm2 for five hours and dried at 140°C. The resulting graphene electrode is highly porous, which allows the electrode to accommodate much more electrolyte. And this determines the amount of charge the supercapacitor can hold. The team has measured the performance of the supercapacitor and it is said to store energy at a density of more than 64Wh/kg at a current density of 5A/gramme. That is almost comparable with lithium-ion batteries, which have an energy density of between 100 and 200Wh/kg.

The engineers say they can fully charge the supercapacitor in just 16 seconds and have repeated this some 10,000 times without a significant reduction in capacitance. This is significant as it also offers a practical alternative to the more limited working life of a lithium ion battery. The cost of the supercapacitor technology has not yet been revealed however.

Related Content

  • Significant diesel hybridisation trend in Europe
    April 30, 2012
    Over the last two decades, diesel engines have become more popular among European consumers, due to their higher fuel efficiency, lower CO2 emission values and fun-to-drive perception when compared to gasoline engines.
  • Innovative fuel injection reduces emissions
    February 24, 2012
    Stricter emissions legislation mean that new engine technology and integrated drivetrain systems are being developed. With the Tier 3/Stage IIIA emissions legislation now in place in North America and Europe, the major engine manufacturers already have an array of solutions on the market. The coming Tier 4 interim/Stage IIIB legislation will be tougher still and most firms are well in hand with their plans to use both in-cylinder and exhaust after-treatment technology. While engines themselves are staying b
  • Sustainable road construction: current practices and future concepts
    November 23, 2015
    The road sector produces the highest level of greenhouse gas, directly, through fossil energy used in mining, transportation, paving works... and indirectly through the emissions coming from vehicles.
  • Innovative earthmovers coming to market
    October 12, 2017
    A wide range of innovative earthmover solutions is now coming to market - Mike Woof writes Generally with major construction equipment exhibitions timed for the second quarter of each year, this is when manufacturers will roll out their latest earthmoving solutions. However 2017 has turned out to be something of an anomaly, with the major firms continuing to unveil new models. Firms have introduced new wheeled loaders, excavators, and dozers, although arguably, some of the most interesting developments