Skip to main content

New alternative to batteries for EVs

A new development looks set to offer an efficient alternative to lithium ion batteries for use in electric vehicles (EVs). At present the current generation of EVs feature lithium-ion batteries to store energy. However the performance of the lithium ion batteries has been criticised, particularly with regard to the recharge time required as this is considerably longer than the time needed to refuel a combustion engine-powered vehicle. While faster charging technologies are available for lithium ion batterie
November 15, 2013 Read time: 3 mins
A new development looks set to offer an efficient alternative to lithium ion batteries for use in electric vehicles (EVs). At present the current generation of EVs feature lithium-ion batteries to store energy. However the performance of the lithium ion batteries has been criticised, particularly with regard to the recharge time required as this is considerably longer than the time needed to refuel a combustion engine-powered vehicle. While faster charging technologies are available for lithium ion batteries, these reduce battery life considerably. The charging time has been identified as a major reason for the slow adoption rate of EVs around the world. However a team of engineers is working on a novel solution by developing a graphene supercapacitor that can store almost as much charge as a lithium ion battery but charges in just 16 seconds.

This new capacitor is being developed at the Gwangju Institute of Science and Technology in South Korea. The team’s high-performance supercapacitors use graphene and are said to store almost as much energy as a lithium-ion battery. In terms of practicality, they can charge and discharge in seconds, and maintain 98% of their initial value after 10,000 cycles.

The project is using a highly porous form of graphene that has a very large internal surface area. This material is produced by reducing graphene oxide particles with hydrazine in water agitated with ultrasound. The graphene powder is then packed into a coin-shaped cell, a pressure of 300kg/cm2 for five hours and dried at 140°C. The resulting graphene electrode is highly porous, which allows the electrode to accommodate much more electrolyte. And this determines the amount of charge the supercapacitor can hold. The team has measured the performance of the supercapacitor and it is said to store energy at a density of more than 64Wh/kg at a current density of 5A/gramme. That is almost comparable with lithium-ion batteries, which have an energy density of between 100 and 200Wh/kg.

The engineers say they can fully charge the supercapacitor in just 16 seconds and have repeated this some 10,000 times without a significant reduction in capacitance. This is significant as it also offers a practical alternative to the more limited working life of a lithium ion battery. The cost of the supercapacitor technology has not yet been revealed however.

Related Content

  • Emissions regulation leads to efficiency gains
    November 6, 2012
    Innovative technology is use is providing efficient, clean burning engines - Mike Woof reports The development of new diesel engine technology has, for the off-highway equipment sector, been the single most expensive research field for the industry since these machines first started being manufactured. Aimed at reducing the emissions of nitrous oxide as well as particulate matter, in a phased series of stages the engine emission improvements will make major changes to the construction sector. In real world
  • New engine manufacturing facility
    June 27, 2023
    Rolls-Royce opens a new engine manufacturing facility.
  • Graphene-enhanced pavements join UK Live Labs programme
    September 1, 2020
    While some parts of the world are on pause, road construction and new technology trials are still underway, as these stories demonstrate - Kristina Smith reports
  • Full-electric: CIFA’s Energya Mixer on Volvo’s BEV Truck
    November 14, 2023
    CIFA’s latest addition to Energya: the E9 electric mixer mounted on a Volvo electric truck, a 100% electric vehicle that works in a fully sustainable manner. Energya - CIFA's brand with the first and only range of electric machines in the concrete industry - aims to reduce CO2 emissions and noise pollution on the job site to zero, helping to make the transport and laying of concrete more environmentally friendly. Thanks to the electrical operation, new opportunities are opening up for the use of heavy-duty vehicles, particularly in densely populated historic centres and on sites with restrictions, where lower environmental impact is an added value.