Test track milling with Roadtec

A milling machine from Roadtec has carried out important work at the National Centre for Asphalt Technology (NCAT) test track in the US. The 2.7km NCAT test track is used for asphalt pavement testing and research. As the facility is important to the advancement of asphalt technologies, Roadtec donates its time, equipment and personnel to carrying out rehabilitation work at the test track. An RX900E model was donated by Roadtec to NCAT and was used by David Bussard and Charlie Butler to mill to depths from
September 11, 2018 Read time: 1 min

A milling machine from 1252 Roadtec has carried out important work at the National Centre for Asphalt Technology (NCAT) test track in the US. The 2.7km NCAT test track is used for asphalt pavement testing and research. As the facility is important to the advancement of asphalt technologies, Roadtec donates its time, equipment and personnel to carrying out rehabilitation work at the test track. An RX900E model was donated by Roadtec to NCAT and was used by David Bussard and Charlie Butler to mill to depths from 28.6mm to 1.07m. The machine had to mill the 8.5m-wide track in a number of passes and was fitted with a 2.2m- wide drum, featuring teeth on a 16mm spacing.

Recycling

For more information on companies in this article

Related Content

  • Advances in materials testing
    April 10, 2012
    Quicker, better, more cost effective materials testing - Kristina Smith writes. Most developments in materials testing technology involve updating and upgrading existing machines, either to meet changes to standards or to satisfy new needs in the market. And occasionally, a manufacturer will come up with something completely new. PUMA - the precision unbound materials analyser - falls into the latter category. It has been developed by Cooper Research Technology and Nottingham Transportation Engineering Cen
    Read More
  • Demand for asphalt testing solutions
    February 14, 2012
    Asphalt testing is performed for a variety of reasons by a variety of companies. Patrick Smith reports Road safety is in the interest of everyone and today it is also an important target shared by the majority of the companies involved in road design and construction. The growing attention paid to this value has had a remarkable effect on the material testing field, encouraged by an increasing market demand for testing solutions as well as by the new technical requirements established by international st
    Read More
  • Airport runway rebuild at Bologna
    May 15, 2019
    Rebuilding a runway requires special attention to detail to maximise efficiency and safety Airport runways face special challenges with regard to the loads they carry on a daily basis, particularly when aircraft are landing. A modern jet aircraft will typically land at speeds of around 240-260km/h, with a laden 747 weighing as much as 265tonnes at the end of a long flight. The stresses these large aircraft place on runway surfaces are enormous and not just with the massive impact forces exerted during
    Read More
  • Latest bitumen mixes improve roads, reduce noise
    February 14, 2012
    Special bitumen mixes and machines are capable of improving the service life of roads and reducing noise. Mike Woof and Patrick Smith report. The need to improve traffic flow in an important part of the City of Poznan, Poland, led to the decision to build a new 1.13km long dual carriageway.
    Read More

Highlighted Content