Specialist supplying Sussex surfacing

Contractor FM Conway will carry out major resurfacing works in the UK. The £56 million deal is with East Sussex County Council, operating as specialist surfacing sub-contractor to the Costain CH2M joint venture. This is a seven year deal involving surfacing as well as maintenance and patching work. FM Conway will be using its novel Enviro range of asphalt base and binder products for the road rebuilding work, reducing the quantities of primary aggregates required in the job.
June 30, 2016 Read time: 1 min
Contractor FM 2329 Conway will carry out major resurfacing works in the UK. The £56 million deal is with East Sussex County Council, operating as specialist surfacing sub-contractor to the Costain CH2M joint venture. This is a seven year deal involving surfacing as well as maintenance and patching work. FM Conway will be using its novel Enviro range of asphalt base and binder products for the road rebuilding work, reducing the quantities of primary aggregates required in the job.
Asphalt milling, paving & compaction

For more information on companies in this article

Related Content

  • How Hitex changed its products to meet the demands of India’s roads
    December 7, 2016
    The Indian Government is keen to embrace new technologies and ideas from overseas but as Hitex International discovered, Indian roads need very special products - Kristina Smith reports
    Read More
  • Concrete surface for runway paving job
    January 18, 2016
    The Fort Lauderdale-Hollywood International Airport in Broward County, Florida, was suffering departure delays on every single flight. The existing 9R-27L runway was too short at 1615m in length, affecting capacity at the airport. To deal with the issue, the Broward County Board of County Commissioners created a plan to extend the southern runway to 2438m to accommodate larger commercial aircraft. The project was not simple however and could not be achieved by tearing out the existing runway and buil
    Read More
  • Milling versatility on German road job
    March 22, 2017
    Milling efficiently with a versatile, mid-sized machine has offered benefits on a German road job. A German contractor has found that using a mid-sized milling machine from Wirtgen has offered a good combination of both versatility and productivity for a road rebuild job. Kassel-based milling specialist VORO has used a Wirtgen W 100 CFi to upgrade the surface of a section of the busy B3 route. The B3 is an important route and runs 755km from Buxtehude in the north of Germany through to the Swiss border in t
    Read More
  • Amey to help with ADEPT Live Labs 2
    September 14, 2023
    The ADEPT Live Labs 2: Decarbonising Local Roads programme in the UK will look at ways to make the highways circular economy more sustainable.
    Read More

Highlighted Content