Short tailswing excavator gains access

In Germany a short tailswing excavator from Doosan has carried out a tricky demolition project. The DX235LCR machine was used to demolish an old residential property, located in close proximity to a road. Belgian demolition contractor Klaus Anthes was brought in to carry out the work in Eppstein in Germany, and used the 24tonne excavator for the job. The work was tricky as the house was located on the side of a hill and also next to a narrow road. However traffic could not be disturbed so the machine had to
November 29, 2012 Read time: 2 mins
The reduced radius Doosan excavator was able to demolish a property without disturbing traffic on the narrow road next to it
In Germany a short tailswing excavator from 695 Doosan has carried out a tricky demolition project. The DX235LCR machine was used to demolish an old residential property, located in close proximity to a road. Belgian demolition contractor Klaus Anthes was brought in to carry out the work in Eppstein in Germany, and used the 24tonne excavator for the job.

The work was tricky as the house was located on the side of a hill and also next to a narrow road. However traffic could not be disturbed so the machine had to work within the boundary of the property. Meanwhile the existing natural stone cellar had to be left in place as this was to provide the base for the new property planned for the site, while the garden to the rear also had to be left as this is in a protected natural area.

The contractor rented the excavator along with a sorting grapple from 1130 Bobcat Bensheim. The 24tonne excavator was useful for this project as it features a short radius design with only 185mm of overhang and a swing diameter of just 3.99m, allowing the contractor to work in confined spaces. Reach and stability were also important, to allow the machine to work on the slope.
Earthmoving & soil compaction

For more information on companies in this article

Related Content

  • Soilmec’s Eagle soars
    December 13, 2021
    Soilmec is now offering what it calls an “entry level” hydraulic drilling rig, the SR-30 Eagle.
    Read More
  • Machine control used for road revamp for Arkansas highway
    June 23, 2015
    A historic route in the US state of Arkansas has benefited from the use of machine control during its upgrade The south-west - north-east US Route 67 in Arkansas has long been a significant transport route. This old road follows the natural break between the Ozark Mountains and the Ouachita Mountains. In the 1920s, funding became available for road paving, and the route was designated US Route 67.
    Read More
  • Special concrete paver for UK road job
    January 5, 2015
    A specially adapted Wirtgen SP25i concrete slipformer has been used on the M6 motorway near Cannock in the UK. The machine worked together with a Wirtgen ISF25i (independent side feeder) in order to pave a concrete slab under difficult conditions. With an overall length of 373km, the M6 is the longest and one of the most heavily congested motorways in the UK. The M6 connects the M1 motorway near Rugby with Carlisle near the Scottish border. But due to the steadily growing volume of traffic, the Highways
    Read More
  • Improving a key route through Florida
    November 9, 2015
    Upgrading a key route through Florida – novel construction techniques are helping widen a road in difficult geological conditions – Lucio Garofalo reports. A major road widening project underway in Florida is due for completion soon. The work will improve an important section of road, reducing congestion at peak period and cutting travel times for drivers. The US 331/SR83 highway runs for some 79km and provides an important link in Florida’s Panhandle area, as it connects with Route 98.
    Read More

Highlighted Content