Short tailswing excavator gains access

In Germany a short tailswing excavator from Doosan has carried out a tricky demolition project. The DX235LCR machine was used to demolish an old residential property, located in close proximity to a road. Belgian demolition contractor Klaus Anthes was brought in to carry out the work in Eppstein in Germany, and used the 24tonne excavator for the job. The work was tricky as the house was located on the side of a hill and also next to a narrow road. However traffic could not be disturbed so the machine had to
November 29, 2012 Read time: 2 mins
The reduced radius Doosan excavator was able to demolish a property without disturbing traffic on the narrow road next to it
In Germany a short tailswing excavator from 695 Doosan has carried out a tricky demolition project. The DX235LCR machine was used to demolish an old residential property, located in close proximity to a road. Belgian demolition contractor Klaus Anthes was brought in to carry out the work in Eppstein in Germany, and used the 24tonne excavator for the job.

The work was tricky as the house was located on the side of a hill and also next to a narrow road. However traffic could not be disturbed so the machine had to work within the boundary of the property. Meanwhile the existing natural stone cellar had to be left in place as this was to provide the base for the new property planned for the site, while the garden to the rear also had to be left as this is in a protected natural area.

The contractor rented the excavator along with a sorting grapple from 1130 Bobcat Bensheim. The 24tonne excavator was useful for this project as it features a short radius design with only 185mm of overhang and a swing diameter of just 3.99m, allowing the contractor to work in confined spaces. Reach and stability were also important, to allow the machine to work on the slope.
Earthmoving & soil compaction

For more information on companies in this article

Related Content

  • Advanced asphalt compaction machine deliver quality surfaces
    May 21, 2014
    Manufacturers are introducing new compaction machines to meet the latest market requirements - Mike Woof writes
    Read More
  • Innovative machine control systems for Canadian slipforming work
    November 29, 2013
    Advanced machine control technologies are speeding site layout and construction operations Canadian house building firm Mattamy Homes has brought in a contractor that has used sophisticated equipment to build the roads around its new development in Oakville, Ontario. The site is just 30 minutes drive from Toronto. Phase 1-A of the project is under construction and nearly every one of the 550 homes that will be built there has been sold already. Additional phases will bring the total number of homes to 1,800
    Read More
  • Indeco cuts up New York City’s old Kosciuszko Bridge
    November 23, 2017
    An Indeco ISS 45/90 is proving essential for demolishing the old Kosciuszko Bridge in New York City. New York City’s old 1.9km Kosciuszko Bridge, which crosses Newtown Creek connecting Green Point, Brooklyn with Maspeth, Queens, has been out of service since April. By the end of the year, the polygonal Warren through-truss structure will be no more. To replace the old bridge, in 2009, the New York State Department of Transportation planned the construction of two cable-stayed replacement bridges.
    Read More
  • Developments in excavators and loaders
    February 14, 2012
    In the earthmoving sector, much development is being seen in excavators and wheeled loaders used for digging and loading, Mike Woof reports
    Read More

Highlighted Content