Latest drilling system performs even better

Atlas Copco says that the third generation of its COPROD drilling system offers even better performance than before.
February 17, 2012 Read time: 1 min
Atlas Copco's new COPROD drilling system offers low-noise, straight hole drilling
161 Atlas Copco says that the third generation of its COPROD drilling system offers even better performance than before. The company offers this with two surface drilling rig platforms and five different drillstrings. ROCF9CR is the smaller of the two rigs and can use CR76 or CR89 drillstrings for blastholes ranging from 90-127mm in diameter. The ROCL740CR is a second generation COPROD drilling rig and can be equipped with CR89, CR102, CR127 or CR140 units to drill holes from 105-180mm in diameter.

A patented plastic stabiliser further improves hole straightness and helps reduce noise emissions. The welded centre guides in the drill tubes have been replaced with a full length inner tube and this patented plastic stabiliser acts as an inner lining, reducing vibrations and noise levels. Field tests have shown that this reduction in noise also allows COPROD rigs to operate without causing unnecessary noise pollution.
Earthmoving & soil compaction

For more information on companies in this article

Related Content

  • New blasthole drillrigs from Sandvik
    December 8, 2014
    Sandvik is broadening its tophammer drill rig range with the introduction of two new models, the Pantera DPi 6.0 and Dino DC400Ri. The Pantera DPi 6.0 is a further development of the well-proven DPi series and now features a redesigned operating system combined with a completely new rockdrill. The redesigned control system has an updated user interface and touch screen, with support for new drill rig options and improved troubleshooting functions. In addition this revamped control system comes with improved
    Read More
  • Caterpillar drill performing in US quarry
    May 11, 2015
    A Caterpillar top hammer rig is said to be working well in a tough granite quarry operation in the US. The MD5150C rig is out-performing down-the-hole (DTH) rigs, with higher productivity and lower fuel consumption. Of note though is the fact that the machine is also delivering comparable hole straightness to the DTH machines. Iron Mountain Quarry is located to the south of St Louis, Missouri and the operation says that overall productivity from its Cat rig is almost double that of the earlier gener
    Read More
  • Caterpillar drill performing in US quarry
    May 11, 2015
    A Caterpillar top hammer rig is said to be working well in a tough granite quarry operation in the US. The MD5150C rig is out-performing down-the-hole (DTH) rigs, with higher productivity and lower fuel consumption. Of note though is the fact that the machine is also delivering comparable hole straightness to the DTH machines. Iron Mountain Quarry is located to the south of St Louis, Missouri and the operation says that overall productivity from its Cat rig is almost double that of the earlier gener
    Read More
  • Rockmore International unveils ROK 550T drill
    April 26, 2018
    Rockmore International has launched its new ROK 550T drill for the European market. The latest addition to the company’s T Series DTH hammer line, the 127mm class product uses the industry-standard QL5/QL50 bit shank, but with the blow tube/foot valve (plastic tube) removed. Pejman Eghdami, Rockmore executive vice president, said: “Plastic parts do tend to break in deep hole drilling, causing the hammer to stop leading to costly downtime. Others have tried removing the plastic tube but they lose a lot of
    Read More

Highlighted Content