Weathering WIM installation

Kistler says that its new smartphone App has made it easier to properly install sensors for its weigh-in-motion systems.
March 8, 2021 Read time: 2 mins
Thanks to an app from sensor manufacturer Kistler, documentation is easier and more practical

Sensors in the road surface record the weight of vehicles while driving – without impairing the flow of traffic. But installation has involved a considerable inconvenience - having to document the process on paper forms, notes Kistler, a global Swiss company that focuses on measurement technologies for dynamic pressure, force, torque and acceleration.

Thanks to its new app, documentation is not only easier and more practical, but also comes with the extra advantage of real-time support from WIM specialists.

Sensor installation usually takes only a few hours. However, factors such as weather on the day of installation or road conditions, can significantly affect the durability of measurement equipment and sensors. These factors also influence the quality of measurements.

For instance, when installed in a wet slot, the adhesion of the grout will be weak, leading to bad fixation of the sensors in the road. To ensure the sensors’ longevity and accuracy and to grant the customer full warranty, the installation process has to be documented carefully. Usually, this means filling out pages-long paper forms at the installation site. But this is rarely very practicable, especially during a night-time installation or when standing in the middle of a road in windy weather. The forms are often lost or illegible - or technicians simply forget about them.

Thanks to the new WIM app from Kistler, documentation is now more practical and less time-consuming. Technicians easily enter information using a smartphone. The site is located via GPS and a photo of the installation plan functions as the basic site layout. Meanwhile, close-up photos of the pavement suffice as documentation of the road conditions. The sensor is identified by scanning its bar code.

The app is clearly structured and guides users through the installation steps. Green symbols indicate that the form is completed. The data is then submitted to Kistler and assessed by a specialist for immediate feedback and support. The onsite technician receives a PDF report for each WIM site and is notified that Kistler has approved the installation. The app can be used by any registered technician and is available for iOS and Android.

 

Highway & Network Management

For more information on companies in this article

Related Content

  • WheelRight’s John Catling says put the brakes on under-inflation
    September 30, 2016
    It’s official – Britain’s tyres are unloved and under-inflated, according to recent research. But WheelRight’s chief executive, John Catling, believes that the research results are indicative of a global problem.
    Read More
  • Degaroute skipline markings
    May 6, 2016
    Of the 8,050km of tollway roads in the United States, the Illinois State Toll Highway Authority manages 460km of them As part of the maintenance programme for this network of five highways, the Illinois State Toll Highway Authority has partnered with Applied Research Associates to manage and monitor the performance of all their pavement marking programmes, providing recommendations for striping projects.
    Read More
  • Grand achievement for Intermountain
    July 18, 2012
    A versatile solution has helped with a tricky project at the Grand Canyon in the US – Pierre Peltier When Intermountain Slurry Seal, a division of Granite Construction, submitted its bid in 2009 to repair roads and parking lots along the Grand Canyon’s North Rim, the company knew the job would come with challenges. The remote roads leading from Jacob’s Lake, Arizona, to the North Rim Lodge had deteriorated to a point that the Federal Highway Association’s (FHWA) Central Federal Lands (CFL) Highway Division
    Read More
  • Notified Bodies in the field of Vehicle Restraint Systems; ERF calls for a level playing field
    June 8, 2015
    Within the framework of the completion of the internal market, the Member States of the European Union approved the Construction Products Regulation in 2011 Its objective is clear and simple: break down barriers in the field of construction products and create a uniform system of certification that is based on mutual recognition.
    Read More

Highlighted Content