On the level with Intercomp’s LS630-WIM weigh-in-motion system

The system increases facility efficiency by accurately weighing vehicles travelling up to 15km/h. Coupled with the 4.14m-wide weighbridge, nearly any vehicle, including those with a wide load or trailer, can be quickly screened. Intercomp says its weigh-in-motion LS630-WIM system is ideal for high traffic volumes at temporary facilities to monitor axle weight or GVW (gross vehicle weight) compliance. Additionally, the portable system can be used at multiple locations as two people can deploy or stow the s
June 10, 2019 Read time: 2 mins
The system increases facility efficiency by accurately weighing vehicles travelling up to 15km/h. Coupled with the 4.14m-wide weighbridge, nearly any vehicle, including those with a wide load or trailer, can be quickly screened.


1315 Intercomp says its weigh-in-motion LS630-WIM system is ideal for high traffic volumes at temporary facilities to monitor axle weight or GVW (gross vehicle weight) compliance.

Additionally, the portable system can be used at multiple locations as two people can deploy or stow the scale pads, ramps/levellers and output CPU in less than 15 minutes. This makes the dynamic weighing system ideal for avoiding undesirable traffic backups due to weight verification operations.

Two scale pads, four roll-up ramps/levelers and dedicated PT20 WIM CPU, or PC, can fit in the trunk of most full-sized vehicles.

The ramps/levellers keep adjacent axles on plane for optimal results. The system accumulates up to 36 individual axles for gross vehicle weight. It also switches to static mode easily.

Highway & Network Management

For more information on companies in this article

Related Content

  • New Zealand’s Waterview project is moving closer to completion
    December 13, 2016
    New Zealand’s biggest road project is less than a year away from completion, and a lot of progress has been made since World Highways last looked at the project two years ago - Mary Searle Bell reports New Zealand’s Waterview project is moving closer to completion and will be the largest road project in the country. The NZ$2 billion Western Ring Route will see the creation of an alternative motorway to State Highway 1, which runs through the centre of Auckland. The 47km-long motorway will allow a large p
    Read More
  • The concrete plan for drilling
    July 9, 2018
    Four tips for optimising concrete dowel drill performance - *Rick Walstad, E-Z Drill Inc president and CEO
    Read More
  • Improved digging performance
    February 7, 2012
    Komatsu is rolling out its new PC190-8 excavator, which replaces the previous PC180-7 model. The new machine weighs in at up to 20tonnes and features an engine power increase of 7% over the previous model, boosting performance and productivity. Digging output is increased due to features such as a 200mm longer monoboom, and a maximum bucket capacity of 1.14m3. Lifting capacity is increased and the PC190-8 lifts over a tonne more than the PC180-7, while it offers a bucket digging force of 1.2tonnes, which
    Read More
  • Milling machine developments to boost efficiency
    October 20, 2016
    A series of developments in the milling machine market will give customers both greater choice and performance – Mike Woof writes. Competition is heating up in the market for milling machines, which has been dominated for many years by Wirtgen. The German firm still retains a strong share of this market, but is now facing much tougher levels of competition from key rivals, and Atlas Copco, BOMAG, Caterpillar and Roadtec in particular. Meanwhile the market is also seeing the return of another familiar nam
    Read More

Highlighted Content