Laser axle sensors deliver accurate traffic data

The Iowa Department of Transportation in the US has selected Peek's AxleLight non-intrusive laser axle sensors installed in a permanent site along Interstate 35/80 in Des Moines. This is the first time that the AxleLight sensors, normally designed as a temporary study tool, have been installed in permanent roadside cabinets. AxleLight sensors shoot a beam of non-visible laser light across the roadway, just a few centimetres above the pavement. Using these sensors, and the ADR family of Automatic Data Record
February 24, 2012 Read time: 2 mins
The 1229 Iowa Department of Transportation in the US has selected Peek's AxleLight non-intrusive laser axle sensors installed in a permanent site along Interstate 35/80 in Des Moines.

This is the first time that the AxleLight sensors, normally designed as a temporary study tool, have been installed in permanent roadside cabinets.

AxleLight sensors shoot a beam of non-visible laser light across the roadway, just a few centimetres above the pavement. Using these sensors, and the ADR family of Automatic Data Recorders from Peek Traffic, state and municipal governments can count, classify, and analyse traffic flow.

Peek worked with the Iowa DOT to certify that the AxleLight units would satisfy the state's high accuracy requirements in the permanent installation environment. The department is using the AxleLight, along with the solar panels and wind turbines that are powering the units, as both a solid and safe source of valuable traffic flow data, and also as an example of 'green' technology at work.
Highway & Network Management

For more information on companies in this article

Related Content

  • Lighting can affect road safety
    February 5, 2013
    New research carried out jointly by the Lighting Research Center and Penn State have identified links between visibility and safety from roadway lighting. The results are said to hold promise for predicting the safety benefits of new lighting configurations. Identifying when and where to install roadway illumination is a challenge for transportation agencies. Estimating nighttime crash reductions from roadway lighting is difficult in part because lighting tends to be installed along with other improvements
    Read More
  • Using ITS to maximise safety and traffic flow for cycling
    January 22, 2013
    Copenhagen, Denmark, has long been known as one of the world’s leading cities for cycling. In some areas of the city, the modal share of bikes has reached a level of as much as 50 %. And on some of the most frequently used bike paths the average daily number of cyclists is close to 30,000. As these numbers continue to rise, new ways of planning and implementing cycling infrastructure are needed. Increasingly, Danish traffic planners are turning to technology as a tool for planning cycling infrastructure. I
    Read More
  • Efficient asset management to trim maintenance budgets
    January 22, 2014
    Transport infrastructure is taken for granted in many, if not most, developed countries. This has resulted in a shortage of investment in maintenance, posing potential long term cost issues. In many developing nations transport networks are expanding fast, but insufficient thought is also being given to how these will be maintained.
    Read More
  • Texas certification of RetroTek-MU operator a first
    July 27, 2018
    Striping Service and Supply is the first US contractor certified by the Texas Department of Transportation to operate the RetroTek-MU road striping Retroreflectometer. The Texas A&M Transportation Institute stringent certification programme provides a quantitative basis for evaluating the ability of a contractor to operate the RetroTek-MU retroreflectometer. The vehicle-mounted RetroTek-MU - manufactured by Reflective Measurement Systems, based in Dublin, Ireland - measures the retroreflectivity of lo
    Read More

Highlighted Content