Curtains for speeders at Curtin University thanks to Actibump

Curtin University in Perth, Australia, is rolling out more Actibumps for slowing traffic after what is says has been a successful trial of four systems. “We expected the same effect as in Sweden,” said David Eskilsson, general manager at Edeva, the Actibump manufacturer based in Linkoping. “But the decrease in the percentage of speeding drivers from over 70% of all drivers in January to below 25% in October last year on the most difficult site has been better than even we expected.” In January 2018 Curtin
June 10, 2019 Read time: 3 mins
Actibump successful in Australia
Curtin University in Perth, Australia, is rolling out more Actibumps for slowing traffic after what is says has been a successful trial of four systems.


“We expected the same effect as in Sweden,” said David Eskilsson, general manager at 5190 Edeva, the Actibump manufacturer based in Linkoping. “But the decrease in the percentage of speeding drivers from over 70% of all drivers in January to below 25% in October last year on the most difficult site has been better than even we expected.”

In January 2018 Curtin University installed four of the active speed bumps to reduce the number of speeding drivers, particularly on semester week days when there are a lot of pedestrians and vehicles on campus. Each day around 2,000 vehicles use the street which has a speed limit of 40km/h.

“The use of the smart speed bumps also provides a steadier flow of traffic, which makes it easier for pedestrians to judge the speed of the approaching vehicle,” said Graham Arndt, director of operations and maintenance at Curtin University. “Additionally, the units have been maintenance free and operated continuously for a year without the need for any intervention.”

Arndt said the university will be installing another set of two active speed bumps on Townsing Drive and another active speed bump will replace a so-called dumb bump - a moulded black plastic bump near the Manning Road entrance. The Actibump traffic safety system allows full accessibility for all vehicles driven at, or under, the set speed limit. Speeding vehicles are physically reminded of the speed limit by an inverted speedbump. A radar measures the speed of the oncoming vehicles and speeding vehicles activate a hatch that is lowered a few centimetres into the road surface. Drivers were surprised to see the road “disappear in front of them” and this made them slow down, said Arndt.

For non-speeders the hatch remains level with the road surface. Edeva says that  independent evaluations have shown that the system decreases the noise, improves yielding behaviour and decreases the speed to that of the speed limit of around 3km/h, regardless of speed limit or previous speeding behaviour.

Speed limit and other variables are set through a web-based interface that also presents the statistics collected by the system.

Edeva says that around 50 Actibump units have been installed worldwide, with most of them in Sweden including in Linköping, Malmö, Helsingborg, Karlstad and two of them are installed in Ystad, on the European road network E65 owned by the Swedish Transport Administration.

Highway & Network Management

For more information on companies in this article

Related Content

  • Swedish company develops new traffic calming technology
    April 24, 2012
    Swedish company Edeva, which was hived off from Prodelox, has successfully tested a new traffic calming method in Linköping Sweden. The technology, called Actibump, monitors traffic approaching a dangerous junction and if cars are exceeding the speed limit a metal trough is activated in the road that cars then bounce over. The trough is six centimetres deep, which the developers say is deep enough for drivers to notice but does not cause any physical damage to either the car or its occupants.
    Read More
  • Skanska and Kraton boost RAP use with called SYLVAROAD™ RP1000
    November 23, 2017
    The city of Västerås in central Sweden is known as a centre for industrial automation and information technology. Innovation abounds here and with it comes strong environmental efforts – meeting carbon reduction goals and maximising the recycling process, for example. A road construction project just outside this picturesque city highlights such innovation.
    Read More
  • Philipp Swarovski lays down the marker
    June 10, 2019
    Swarco’s chief operating officer Philipp Swarovski shares his thoughts on highway safety and infrastructure in an age of uncertain future needs. David Arminas reports It was in Austria in 1969 when Manfred Swarovski opened his first glass bead factory. Five years later, operations started in the US. As the years rolled by there followed acquisitions and expansion of manufacturing facilities as well as a shift into intelligent transportation systems globally. Fast forward to 2019 and the family compan
    Read More
  • Skanska and Kraton boost RAP use with called SYLVAROAD™ RP1000
    November 23, 2017
    The city of Västerås in central Sweden is known as a centre for industrial automation and information technology. Innovation abounds here and with it comes strong environmental efforts – meeting carbon reduction goals and maximising the recycling process, for example. A road construction project just outside this picturesque city highlights such innovation.
    Read More

Highlighted Content