Tackling congestion on Arkansas link

Engineering firm Michael Baker International has helped deliver highway improvements for a key link in Arkansas. The upgrade to Highway 70 involves widening and is designed to boost capacity along a 30km stretch of the route.
June 14, 2017 Read time: 1 min

Engineering firm Michael Baker International has helped deliver highway improvements for a key link in Arkansas. The upgrade to Highway 70 involves widening and is designed to boost capacity along a 30km stretch of the route. Michael Baker International completed a US$4.5 million design project for the Arkansas State Highway and Transportation Department (AHTD) is for widening of the section of Highway 70 from two lanes to four.

The firm carried out an environmental study and provided roadway widening design. This included replacement of the existing Caney Creek Bridge and two bridges over Ten Mile Creek. The firm came up with a design to widen and corrected deficiencies in road curve radii and super-elevation, flattening subgrade slopes on the low side of super-elevated sections to minimise ditch depths and right-of-way takes. The firm also designed a solution to add a long sweeping curve at the existing intersection with the I-30 Frontage Road to allow trucks to safely use the intersection for turns.

Highway & Network Management

Related Content

  • Nigeria road upgrade to boost capacity
    August 17, 2018
    Nigeria’s Federal Executive Council, (FEC) is giving its approval for an upgrade of the road running from Akwanga to Gombe. The 421km section of the A3 runs between Akwanga, Jos, Bauchi and Gombe and provides an important link between the centre of the country and Nigeria’s north east. A budget of US$973.6 million has been set for the work, which is expected to take four years to complete. The work involves widening the existing two lane highway into a dual carriageway with two lanes in either direction
    Read More
  • Asphalt milling optimised by 3D controls
    February 20, 2012
    3D machine controls can optimise milling efficiency, Mike Woof reports. More efficient milling and recycling operations can be carried out by using the latest 3D control systems on the market. At the last Trimble Dimensions event in Las Vegas, the advantages of 3D controls for milling operations proved a key topic. The use of 3D control systems can offer huge advantages in milling operations. This technology helps increase productivity as the milling machine will only remove what is required, which also hel
    Read More
  • Washington DC’s historic bridge replacement project
    June 11, 2019
    The project to replace a historic bridge in US capital Washington DC is providing major challenges for its builders - Mike Woof writes
    Read More
  • Concrete paving in Indiana
    April 2, 2021
    Important concrete paving work has been carried out in Indiana on key highway connections
    Read More

Highlighted Content