Swarco signs for slower Swansea speed limit

In March, the Welsh government passed a law which from September will see the default speed limit on restricted roads in Wales reduced from 30mph (50kph) to 20mph (32kph).
By David Arminas June 30, 2023 Read time: 2 mins
The signs are all being manufactured and rigorously tested at Swarco’s factory in Melsonby in the English county of North Yorkshire (image courtesy Swarco UK & Ireland)

Swarco has signed an agreement with the Welsh city of Swansea to design and install signage to support the new 32kph (20mph) urban speed limit.
 
In March, the Welsh government passed a law which from September will see the default speed limit on restricted roads in Wales reduced from 30mph (50kph) to 20mph. To support the upcoming changes to the speed limit, local authorities in Wales are working to make the necessary alterations to existing highway signage to ensure drivers are aware of the changes.
 
Following an open competitive tender process on Sell2Wales in late 2022, Swansea Council entered into a commercial contract with Swarco to replace its existing vehicle speed activated signs (VAS) with new electronic sign units that dynamically display the approaching vehicle’s actual speed. These signs will display the vehicle speed in ‘GREEN’ if the vehicle is complying with the new default speed limit and in ‘RED’ if not. This new contract is designed to work in co-ordination with an existing service and maintenance contract which was already in place.
 
The new agreement will see Swarco install 120 bespoke vehicle activated signs throughout Swansea. The signs, which are all manufactured and rigorously tested at Swarco’s factory in Melsonby in the English county of North Yorkshire, feature Swarco’s EPIX lens technology system to ensure the lowest power consumption.
 
The signs use a radar to detect vehicle speeds and use an energy efficient LED display to clearly show messages to oncoming drivers, as well as being equipped with highly intelligent internal data logging, which is stored within the signs, to provide statistical feedback and data on the number of activations, vehicle speeds and volumes. The council will be able to easily monitor changing driver behaviour.
 
“We are pleased to further extend our working relationship with Swansea Council,” said Derek Williamson, business development manager at Swarco UK & Ireland. “We have worked closely with them to fully understand their requirements and have designed a high quality, reliable, durable and energy efficient solution that delivers a low lifetime cost.”

Highway & Network Management

For more information on companies in this article

Related Content

  • New urban speed limits for Europe?
    May 4, 2012
    EU proposals have been forward suggesting tougher speed control for built-up urban areas in Europe's towns and cities. In places where there is a perceived risk from speeding, such as around schools or in town and city centres and residential areas, speed limits of 30km/h (20mph) could be imposed.
    Read More
  • Weigh in motion technology reduces road damage
    February 8, 2012
    Overweight vehicles cause enormous damage to road structures but they can be caught, even at high speed. Weigh-in-motion or WIM devices are designed to capture and record axle weights and gross vehicle weights as vehicles drive over a measurement site.
    Read More
  • Automated speed camera enforcement: IRF sets the measure for use
    August 3, 2020
    Familiarly known as “speed cameras” to motorists around the world, automated speed enforcement (ASE) devices produce a record of the speed of a vehicle when the driver has exceeded the acceptable maximum limit. However, as recently publicised cases have shown, for an ASE system to be effective and widely accepted, it is of paramount importance that all readings from these devices are accurate, and that this accuracy can be proven by those operating the devices.
    Read More
  • New barriers coming to market worldwide
    July 28, 2015
    European and US manufacturers traditionally hold strong positions in the global market for road safety barrier systems. The strength of the European and US testing systems and processes as well as their respective legislation have helped this position. Both European and US standards for road safety barriers are well understood in other territories and are also accepted in many countries around the globe.
    Read More

Highlighted Content