Royal treatment for Hull’s Princes Quay Bridge

Finishing touches are being put on Princes Quay Bridge in the northern English city of Hull, in East Yorkshire county, for opening this spring.
By David Arminas January 30, 2020 Read time: 2 mins
The Princes Quay Bridge for cyclists and pedestrians sits over the A63 in the English city of Hull

The €14 million bridge spans the A63 and, when open, will enable pedestrians and cyclists to cross over the busy dual carriageway.
 
The assembled 60m-long bridge – weighing 150tonnes - was delivered to its final position last November and then manoeuvred through closed streets into position over the A63 during a single night. The marina platform has been completed, the supports for the steel ramps have been installed and construction has started on the bridge ramps and stairs.
 
Concrete work on the bridge, laying the paving, landscaping and finishing the ramps will complete the project for an opening something this spring.

The Highways England project, which is the first phase of the A63 Castle Street road improvement scheme, will shape the future of Hull and connect key sites in the city. The bridge is expected to open in the spring which will signal the start of the main scheme.
 
The proposed €417 million main scheme will create a junction by lowering the level of the A63 at the Mytongate junction. Ferensway and Commercial Road will cross the A63 creating a split-level junction.

Between Princes Dock Street and Market Place the proposal is to widen the eastbound carriageway to three lanes and build another footbridge over the A63, this time at Porter Street.

Highway & Network Management

Related Content

  • Busy bridge in Beijing replaced quickly
    March 31, 2016
    The replacement of a very busy road bridge in China’s capital Beijing has been carried out successfully. Due to the volume of traffic using the bridge during week days, the work had to be carried out quickly so as to minimise traffic disruption. But despite being carried out in the centre of Beijing, the replacement work for the Sanyuan Bridge just took 43 hours from start to completion.
    Read More
  • Bertha ends her Alaskan Way voyage in Seattle
    December 21, 2017
    Seattle's State Route 99 viaduct is coming down. David Arminas was on site. Bertha, the world’s largest diameter earth pressure balance tunnel boring machine, with a cutterhead diameter of 17.5m, is no more. Her 2.7km journey underneath the waterfront area of Seattle finished on April 4 and the power went off for the last time on an extraordinary TBM that had finally completed an extraordinary job. “A small sidewalk job would have had more impact on city traffic than we have had,” says Brian Russell a v
    Read More
  • Sunderland’s sliding bridge slips across the Wear
    October 26, 2016
    Slowly but surely, a 2,500 tonne section of a new bridge deck was eased out from the banks of the River Wear near Sunderland in northern England. It now straddles the water, pointing towards the opposite bank which it will eventually reach after another sliding operation next year likely. The project to build the New Wear Crossing is now half way through with the first half of the steel deck bridge poised mid-river. Completion of the bridge is expected in the spring of 2018. This month, hydraulic jack
    Read More
  • Economic gains from widening the A453 in Nottingham, England
    August 12, 2014
    Work is well underway on turning a busy just over 11km two-lane link road from the city of Nottingham to Junction 24 of the M1 in Leicestershire, England into a four-lane highway. The widened highway will relieve considerable peak-time congestion for travellers to Nottingham, the M1 and East Midlands Airport while also making journeys safer and more reliable. Guy Woodford reports Used by up to 30,000 vehicles a day, the A453 is renowned for congestion at peak travel times. But years of day-to-day commuter a
    Read More

Highlighted Content