Royal treatment for Hull’s Princes Quay Bridge

Finishing touches are being put on Princes Quay Bridge in the northern English city of Hull, in East Yorkshire county, for opening this spring.
By David Arminas January 30, 2020 Read time: 2 mins
The Princes Quay Bridge for cyclists and pedestrians sits over the A63 in the English city of Hull

The €14 million bridge spans the A63 and, when open, will enable pedestrians and cyclists to cross over the busy dual carriageway.
 
The assembled 60m-long bridge – weighing 150tonnes - was delivered to its final position last November and then manoeuvred through closed streets into position over the A63 during a single night. The marina platform has been completed, the supports for the steel ramps have been installed and construction has started on the bridge ramps and stairs.
 
Concrete work on the bridge, laying the paving, landscaping and finishing the ramps will complete the project for an opening something this spring.

The Highways England project, which is the first phase of the A63 Castle Street road improvement scheme, will shape the future of Hull and connect key sites in the city. The bridge is expected to open in the spring which will signal the start of the main scheme.
 
The proposed €417 million main scheme will create a junction by lowering the level of the A63 at the Mytongate junction. Ferensway and Commercial Road will cross the A63 creating a split-level junction.

Between Princes Dock Street and Market Place the proposal is to widen the eastbound carriageway to three lanes and build another footbridge over the A63, this time at Porter Street.

Highway & Network Management

Related Content

  • First concrete beam raised for new Mersey bridge link
    December 11, 2015
    The first concrete bridge beam for a junction on the new Mersey Gateway route has been lifted into place. Work is underway on a major road junction for the Mersey Gateway Project, with the first of 156 of the concrete beams has been lifted into place as work ramps up at a major road junction. A 550tonne capacity crane lowered the 106tonne beam into position at the Bridgewater junction in Runcorn, where the new Astmoor Bridgewater viaduct is being built over the Bridgewater canal. Two elevated slip roads ar
    Read More
  • Innovative, flexible bridge formwork systems
    February 14, 2012
    Innovative formwork systems have been used to construct a variety of bridge structures. Patrick Smith reports. As part of the work on Germany's new A4 autobahn near Eisenach, the contracting joint venture awarded the formwork contract for two of the three viaducts to Doka. What makes this assignment so special to the company is that although the two steel composite bridges each have very different cross-sections, the JV is using the same overslung composite forming carriage to pour the carriageway slabs of
    Read More
  • Bridges in Sunderland and Poland are being slid into place
    February 6, 2017
    Sunderland sees a bridge slide into place and two bridges inch their way across a Polish highway Slowly but surely, a 2,500 tonne section of a new bridge deck was eased out from the banks of the River Wear near Sunderland in northern England. It now straddles the water, pointing towards the opposite bank which it will eventually reach after another sliding operation likely to take place next year. The project to build the New Wear Crossing is now halfway through with the first half of the steel deck b
    Read More
  • Installation underway of first UK M4/M5 ‘superspan’ gantries
    July 4, 2012
    The installation is underway of the first superspan gantries on the M4/M5 managed motorway scheme. The existing gantries and infrastructure were successfully removed last month while the new steel gantries were being constructed, fitted-out and tested at a dedicated facility located near junction 17 of the M5, before being delivered to the works site. A total of 33 new overhead gantries, a number of which span 50m and weigh over 30tonnes, will be installed along the new managed motorway section up until T
    Read More

Highlighted Content