Skip to main content

Genoa’s San Giorgio Bridge set to open

Contractor Webuild has been completing work, including solar panel installation.
By David Arminas July 31, 2020 Read time: 1 min
Trucks drive across the San Giorgio Bridge in Italy as part of load testing before the structure opens (photo courtesy Webuild)

The San Giorgio Bridge - the Morandi Bridge replacement in Genoa, Italy - will open on Monday following several weeks of load tests.

The tests started earlier this month following the recent near completion of the structure in a record 13 months by contractors Webuild and Fincantieri. The series of tests, conducted by state motorways entity Anas and Rina initially consisted of 16 heavy trucks driving along the bridge during what is called phase zero of a preliminary assessment.

Later, another 56 trucks lorries weighing 44 tonnes each - a combined weight of 2,500 tonnes - put the bridge through further tests.

Static load tests continued in the coming days trucks continued to run along the bridge. The eastern ramp, however, had remote-controlled vehicles on it in the early parts of the tests.

Meanwhile, Webuild has been completing its work preparing the bridge for delivery, installing glass and solar panels, setting up signage and preparing the final layer of asphalt 4cm thick.

The new bridge was designed by Renzo Piano.

The old Morandi Bridge was named after its structural designer but officially called Viadotto Polcevera, or Polcevera Viaduct in English. It was constructed between 1963 and 1967 along Italy's A10 motorway over the River Polcevera.  It collapsed during a severe storm in 2018, which involved multiple fatalities.

Related Content

  • Turkey’s new Marmara Highway project
    June 8, 2017
    By the end of 2018, a shiny new strip of asphalt will skirt around Turkey’s largest city, Istanbul, providing a new transport connection.
  • Bolivia’s new highway
    October 10, 2017
    Bolivia’s new highway will provide better access into mountain areas – Mauro Nogarin writes At the beginning of 2015, work began on the construction and paving for the Tupiza - Atocha - Uyuni highway project. The route is located in Bolivia’s Potosí department: it is 189m in length and forms part of the Southwest Basic Road Network (RVF) of Bolivia.
  • Zipping up road lanes – with Barrier Systems
    September 10, 2018
    QMB has a Lindsay Road Zipper on duty near Montreal. World Highways deputy editor David Arminas climbed aboard As vice president of Canadian barrier specialist QMB, based in Laval, Quebec, Marc-Andre Seguin is sanguine about the future for moveable barriers. On the one hand, it looks good. The oft-stated advantage of moveable barriers is that the systems are cheaper to install than adding a lane or two to a highway or bridge. Directional changes to lanes can boost volume on a road without disrupting tra
  • JCCBI says US$300m for demolishing Montreal’s old Champlain Bridge
    April 11, 2017
    Tearing down the old steel truss cantilever Champlain Bridge in Montreal could cost around US$300 million, according to preliminary estimates by a federal government agency. Also, until the nearby new Champlain Bridge is finished, it will cost US$93 million annually to maintain the old one, according to Jacques Cartier and Champlain Bridges Incorporated (JCCBI), the federal Canadian agency that oversees several major road infrastructure assets in the city. Dismantling will start in 2019 at the earliest and