Skip to main content

Adaptive signal control report

A study of McCain’s QuicTrac adaptive control software, deployed over a year ago by the Californian city of Temecula, has highlighted the array of benefits achievable through an adaptive system. The survey calculated the arterials’ level of service, measured in delay per vehicle, both pre- and post-deployment, evaluating the systems’ benefit-to-cost ratio and environmental impact.
April 30, 2012 Read time: 2 mins
RSSA study of 5198 McCain’s QuicTrac adaptive control software, deployed over a year ago by the Californian city of Temecula, has highlighted the array of benefits achievable through an adaptive system. The survey calculated the arterials’ level of service, measured in delay per vehicle, both pre- and post-deployment, evaluating the systems’ benefit-to-cost ratio and environmental impact.

Considerable congestion levels and queuing on off-ramps during rush hours led the city of Temecula to seek out a solution that would lower congestion and maximise thoroughfare at minimal expense to the city. McCain’s adaptive signal control system was used to optimise signal timing along 83 intersections spanning 29kms of the city’s busiest corridors, including seven traffic signals located at the I-15 freeway interchange.

QuicTrac adaptive signal control reduced delays at 81.3 per cent of the study intersections, yielding a 14 per cent citywide improvement in travel time, 17 per cent increase in corridor speeds, as well as 29 per cent less stops. In addition, the solution delivered a 30:1 benefit-to-cost ratio to the city and is projected to save commuters US$2.6 million in first year travel time and $437,000 in first year fuel costs.

QuicTrac adaptive control software operates through the collection and analysis of real-time data from field detectors, loops or video, establishing traffic flow and demand. The software then runs a series of advanced algorithms to determine and coordinate optimum signal timing for the entire corridor. By coordinating traffic signals based on current conditions, the technology provides a series of green lights, expediting groups of vehicles through arterials.

For more information on companies in this article

Related Content

  • Study for Dallas road development project
    July 14, 2016
    The Texas Department of Transportation (TxDOT) awarded a US$2.75 million contract for a study to develop the corridor along a stretch of Interstate 635 (I-635) in Dallas. The two-year contract is for schematic, environmental and traffic studies for the construction of access roads along the growing section of highway and was awarded to Michael Baker International. As part of the contract, the Michael Baker team will conduct a number of detailed studies in advance of TxDOT’s plans to add more than 53km of
  • Vehicle detection app from Nortech
    May 22, 2019
    Nortech has designed a range of vehicle detectors that can be set up using a smartphone app. This tool can be used to identify the presence of vehicles through an inductive loop buried beneath a road. The vehicle detectors come with new features and are backed up with a compact diagnostic unit that links to a smartphone app. This enables quick and easy detector setup and comprehensive loop fault analysis. Stable and robust, the units offer automatic frequency selection allowing a 7-series detecto
  • Asphalt milling optimised by 3D controls
    February 20, 2012
    3D machine controls can optimise milling efficiency, Mike Woof reports. More efficient milling and recycling operations can be carried out by using the latest 3D control systems on the market. At the last Trimble Dimensions event in Las Vegas, the advantages of 3D controls for milling operations proved a key topic. The use of 3D control systems can offer huge advantages in milling operations. This technology helps increase productivity as the milling machine will only remove what is required, which also hel
  • Fewer cables for Siemens ST950 Plus+ traffic controller
    November 8, 2017
    The latest controller and signals system from Siemens, the ST950 Plus+, uses fewer cables and a smaller controller cabinet than other systems. The aim of the Plus+ solution is to offer significant reductions in on-street installation and maintenance time, improved safety and reduce deployment costs compared to conventional methods. In short, it’s easier and faster to install and later maintain, explained Keith Manston, head of product management for Siemens.