Skip to main content

Adaptive signal control report

A study of McCain’s QuicTrac adaptive control software, deployed over a year ago by the Californian city of Temecula, has highlighted the array of benefits achievable through an adaptive system. The survey calculated the arterials’ level of service, measured in delay per vehicle, both pre- and post-deployment, evaluating the systems’ benefit-to-cost ratio and environmental impact.
April 30, 2012 Read time: 2 mins
RSSA study of 5198 McCain’s QuicTrac adaptive control software, deployed over a year ago by the Californian city of Temecula, has highlighted the array of benefits achievable through an adaptive system. The survey calculated the arterials’ level of service, measured in delay per vehicle, both pre- and post-deployment, evaluating the systems’ benefit-to-cost ratio and environmental impact.

Considerable congestion levels and queuing on off-ramps during rush hours led the city of Temecula to seek out a solution that would lower congestion and maximise thoroughfare at minimal expense to the city. McCain’s adaptive signal control system was used to optimise signal timing along 83 intersections spanning 29kms of the city’s busiest corridors, including seven traffic signals located at the I-15 freeway interchange.

QuicTrac adaptive signal control reduced delays at 81.3 per cent of the study intersections, yielding a 14 per cent citywide improvement in travel time, 17 per cent increase in corridor speeds, as well as 29 per cent less stops. In addition, the solution delivered a 30:1 benefit-to-cost ratio to the city and is projected to save commuters US$2.6 million in first year travel time and $437,000 in first year fuel costs.

QuicTrac adaptive control software operates through the collection and analysis of real-time data from field detectors, loops or video, establishing traffic flow and demand. The software then runs a series of advanced algorithms to determine and coordinate optimum signal timing for the entire corridor. By coordinating traffic signals based on current conditions, the technology provides a series of green lights, expediting groups of vehicles through arterials.

For more information on companies in this article

Related Content

  • Parsons is handling a major interchange project in North Carolina
    June 21, 2017
    Parsons is handling the design for a major interchange project in North Carolina. The firm will carry out key elements of design for the I-26/US 74/NC 108 Interchange Project. The deal was awarded by the North Carolina Department of Transportation (NCDOT).
  • Machine and machine control innovations in concrete paving
    June 28, 2013
    Machine innovations and machine control advances are the latest news in the concrete paving sector - Mike Woof reports. While machine control systems were pioneered in the concrete paving market, continuous refinement of the technologies is offering major improvements for customers. Customers have a choice now of more than one supplier while the packages are said to be more user-friendly than before. And in addition, the systems themselves can be more closely integrated into the machines due to advances mad
  • Toll-tale market strength for leading tolling manufacturers
    May 22, 2014
    New major highway tolling solution supply contracts and the launch of cutting-edge tolling products have invigorated the global tolling technology market in the first half of 2014, as Guy Woodford reports Kapsch TrafficCom has been selected by North Tarrant Express (NTE) Mobility Partners LLC to provide the toll collection, intelligent transport and network communication systems for the NTE extension project in the US state of Texas. The NTE extension is approximately 16km long, and runs along I-35W north o
  • A new tolled highway brings change for Austin, Texas
    February 10, 2020
    A new highway section in Austin, Texas marks a major departure for the southern US city