Ready to rumble? New safety system

Tests by the Transport Research Laboratory (TRL) in the UK show that the use of rumble strips could significantly reduce crashes.
August 22, 2019 Read time: 2 mins

Tests by the Transport Research Laboratory (TRL) in the UK show that the use of rumble strips could significantly reduce crashes. The rumble strips could be installed quickly and cheaply on single lane roads or on roads with a single lane in either direction. These would help reduce the risk of drivers running off the road (RoR), or of inadvertently crossing over into oncoming traffic. The rumble strips can be installed easily and at low cost using simple milling equipment, with this system already in use in many US states as well as elsewhere in the world.

At present, raised rumble strips are only used in the UK along dual carriageways. However TRL says its research offers a good opportunity for Highways England to bring single carriageway sections of the strategic road network up to the same safety standard as the dual carriageway sections.

In the UK, rumble strips are placed primarily on the edge of dual carriageways. However, many other countries also place rumble strips along the edge as well as the centre line of dual and single carriageways to mitigate head-on, side swipe and RoR incidents.

New innovative rumble strip patterns, such as the sinusoidal design which produces less external noise, are increasingly being utilised in the USA and Europe for their higher benefits compared with traditional types.

Road Markings, Barriers & Workzone Protection

For more information on companies in this article

Related Content

  • Scotland’s new Queensferry Crossing over the Forth Estuary
    December 23, 2015
    The new Queensferry Crossing under construction in Scotland will be the third landmark bridge spanning the Forth Estuary - Mike Woof writes When the new Queensferry Crossing over the Forth Estuary opens at the end of 2016, it will be the third landmark bridge to be built spanning this short stretch of water. Lying alongside the existing road bridge and the historic rail bridge, this new structure will be as groundbreaking as the two earlier crossings were at the time of their construction.
    Read More
  • Barrier innovations making roads safer
    February 21, 2013
    Developments in barrier technology continue to make roads safer for drivers - Mike Woof writes. Innovative new barrier technology is helping make roads safer for drivers. Key developments have been made in barrier design, helping ensure road and highway infrastructure is more passively safe. New barrier designs ensure that errant vehicles are redirected into the roadway, with reduced risks for occupants and also other road users. Continuously slipformed concrete barriers reinforced with steel are now widely
    Read More
  • Zipping up road lanes
    September 28, 2018
    QMB has a Lindsay Road Zipper on duty near Montreal. World Highways deputy editor David Arminas climbed aboard As vice president of Canadian barrier specialist QMB, based in Laval, Quebec, Marc-Andre Seguin is sanguine about the future for moveable barriers. On the one hand, it looks good. The oft-stated advantage of moveable barriers is that the systems are cheaper to install than adding a lane or two to a highway or bridge. Directional changes to lanes can boost volume on a road without disrupting tra
    Read More
  • 3D GPR technology makes for speedy surveys
    August 21, 2019
    Traffic-speed surveys using 3D ground penetrating radar (GPR) are slashing the time required for surveying the UK’s motorways, and allowing a more thorough analysis of the pavement layers and condition.
    Read More

Highlighted Content