Dynatest improves its falling weight deflectometer

The pavement engineering firm Dynatest has unveiled its new, Fast Falling Weight Deflectometer (FastFWD). The FastFWD enable users to collect pavement structural data faster than ever before.
January 6, 2017 Read time: 2 mins

The pavement engineering firm 2597 Dynatest has unveiled its new, Fast Falling Weight Deflectometer (FastFWD). The FastFWD enable users to collect pavement structural data faster than ever before.

Dynatest said its FastFWD Model 8012, which was on display at the Transportation Research Board annual meeting in Washington DC this past January, is five times faster than the previous model.

The FastFWD Model 8012 collects 75% more test points per hour.  This means that it can have approximately 45% less traffic exposure. The previous FWD Model 8000 is upgradable to the FastFWD 8012 specification.

The FastFWD patented electro-mechanical system removes the use of hydraulics, making onsite maintenance easy as well as reducing overall maintenance and service costs  However, it has the same sensor setup and user interface as previous FWD models so no major training of operators is needed. The FastFWD is available as a trailer- or truck-mounted version and meets all FWD standards worldwide.

The FastFWD applies a dynamic load that simulates the loading of a moving wheel. The pavement response is analysed with Dynatest's ELMOD (Evaluation of Layer Moduli and Overlay Design) software to determine the elastic moduli, stresses and strains of each modelled layer. ELMOD reports the weakest layer of failure, residual life and determines the optimum rehabilitation alternatives.

Road Markings, Barriers & Workzone Protection

For more information on companies in this article

Related Content

  • Rigorous testing for high performance materials
    February 9, 2012
    Today’s highways require high performance materials, and this means rigorous testing as Patrick Smith reports Highways are under greater pressure than ever today and asphalts have to grant high performances in order to withstand traffic and meet the standards. Studying the plastic permanent deformations in hot mix asphalt (HMA) is very important to obtain useful information for mix designers as an appropriate mix design will reduce the formation of unevenness on road surface. To investigate the effect of mi
    Read More
  • Asphalt and bitumen - testing for performance
    February 29, 2012
    The stresses placed on modern asphalt and bitumen means that specialist equipment is essential to make sure performance specifications are met. As road traffic increases at a rapid pace and road safety becomes a priority issue, asphalt is put under increasingly higher stresses. For example, road surfaces are subject to compression, flexural tensions and tangential stresses: internal friction, depending on the aggregates, and the cohesion, guaranteed by bitumen's composition, are the two main properties whic
    Read More
  • Weigh in motion technology reduces road damage
    February 8, 2012
    Overweight vehicles cause enormous damage to road structures but they can be caught, even at high speed. Weigh-in-motion or WIM devices are designed to capture and record axle weights and gross vehicle weights as vehicles drive over a measurement site.
    Read More
  • Advances in materials testing
    April 10, 2012
    Quicker, better, more cost effective materials testing - Kristina Smith writes. Most developments in materials testing technology involve updating and upgrading existing machines, either to meet changes to standards or to satisfy new needs in the market. And occasionally, a manufacturer will come up with something completely new. PUMA - the precision unbound materials analyser - falls into the latter category. It has been developed by Cooper Research Technology and Nottingham Transportation Engineering Cen
    Read More

Highlighted Content