Skip to main content

Motorway's SolarLite

Motorists are already benefiting from greater visibility on a stretch of the M25 and between the M2 and M20 near the port of Dover, County Kent, south-east England, where Astucia SolarLite studs have been installed. Now drivers between junctions 3 and 6 on the M40 motorway heading north-west from the M25 out of London also benefit from the studs.
February 15, 2012 Read time: 2 mins
Drivers on the M40 motorway in the UK benefit from Astucia's SolarLite studs
Motorists are already benefiting from greater visibility on a stretch of the M25 and between the M2 and M20 near the port of Dover, County Kent, south-east England, where Astucia SolarLite studs have been installed.

Now drivers between junctions 3 and 6 on the M40 motorway heading north-west from the M25 out of London also benefit from the studs.

Astucia recently worked with 3005 Atkins and the 1441 UK Highways Agency to deploy SolarLite studs on the M40.

"SolarLite studs, unlike retroreflective cat's eyes, work intuitively, charging and activating from natural sunlight meaning they're a totally sustainable road safety solution. They also provide up to 900m of visibility: that's ten times greater than that of conventional studs," says 2696 Astucia.

The placement of the 7,000 studs was thoroughly considered. The stretches of road between junctions 3 and 4 and junctions 5 and 6 have been flagged as having perceived high rates of accidents due to the topography, road layout and lack of street lighting, thus the need for clearer road marking.

The Chiltern Hills escarpment, an Area of outstanding National Beauty, sit between junctions 5 and 6, and according to Astucia with the aid of eco-friendly SolarLite road studs, they are protected from pollution damage.

For more information on companies in this article

Related Content

  • Stimsonite Click Stud saves on in-situ replacement time
    April 29, 2015
    Over the past four years, there have been nine road worker deaths on the Highways Agency network in the UK. Statistics such as these are drivers for road authorities to improve health and safety for the workforce on the network. It takes just seconds to replace a Stimsonite Click Stud reflector compared to an average time of eight minutes to remove and replace a conventional bonded road stud. This greatly benefits the Highways Agency by reducing the exposure of road workers to traffic. Conventional
  • Lighting can affect road safety
    February 5, 2013
    New research carried out jointly by the Lighting Research Center and Penn State have identified links between visibility and safety from roadway lighting. The results are said to hold promise for predicting the safety benefits of new lighting configurations. Identifying when and where to install roadway illumination is a challenge for transportation agencies. Estimating nighttime crash reductions from roadway lighting is difficult in part because lighting tends to be installed along with other improvements
  • Workzone safety protects workforce and drivers
    May 3, 2012
    Highway construction work zones are dangerous places, and anything that can improve safety is welcomed as Patrick Smith reports. The safe and efficient flow of traffic through work zones is a major concern to transportation officials, industry, the public, businesses, and commercial motor carriers. This is the view of the US Federal Highway Administration (FHWA), which has developed the Highway Work Zone Safety Program to reduce the fatalities and injurious crashes in work zones, and to enhance traffic oper
  • Permanent DMS in work zones
    February 9, 2012
    Forty-four state agencies currently rely on Daktronics for a total of more than 3,500 dynamic message signs (DMS) to provide important information to motorists. As soon as a new construction project begins, approaching motorists need to know exactly what to expect. Permanent DMS provide the information ahead of time, ahead of the congestion.