Tunnel for Netherlands?

A new tunnel is being proposed in the Netherlands between The Hague and Delft.
March 2, 2012 Read time: 1 min
RSSA new tunnel is being proposed in the Netherlands between The Hague and Delft. The link would run under the existing Prinses Beatrixlaan route. The aim of the tunnel project is to reduce congestion as well as noise pollution as traffic volumes in the area are expected to grow by 30% or more by 2020. The tunnel would provide a link to The Hague, with the existing surface routes then being used for local traffic. The tunnel is expected to cost €190 million to build and a decision on whether to proceed with the project is expected shortly.
Road Structures

Related Content

  • Going mobile in Mexico
    April 12, 2012
    Mexico-based Grupo Pinfra was one of the country's first aggregate producers to invest in mobile crushing and screening equipment. Twenty years on, the company is still confident that mobile equipment is key to meeting demand and has just expanded its fleet. In 1991, Pinfra took delivery of two Metso Minerals Lokotrack LT125 mobile crushers and these have now clocked up 30,000 working hours. Nonetheless, there is still plenty of life in these machines and while the newly acquired LT140 jaw crusher takes
    Read More
  • Saudi Arabian capital Riyadh benefiting from major transport investment
    September 9, 2013
    Saudi Arabia is undergoing a series of upgrades to its transport network in a bid to improve Traffic flow rates and boost safety - Mike Woof reports. The massive growth in the use of motor transport worldwide since the start of the 20th century has transformed every country on the planet. But perhaps no country has changed more dramatically than Saudi Arabia, the world’s leading oil producer. At the start of the 20th century Saudi Arabia’s population was small and the country had few industries while it is
    Read More
  • Paraguay bridge project faces issues
    February 25, 2021
    A Paraguayan bridge project is facing controversy.
    Read More
  • Precision narrows the gap between design software and GIS
    March 20, 2012
    Greater precision is helping blur the boundaries between GIS technology and design software While GIS map based technology has extended its range across an ever more universal spectrum of uses in the highways sector, it is increasingly showing weaknesses for engineering purposes. It is very often not accurate enough. This has not mattered previously because the GIS tool has been seen essentially as an automated version of paper based systems from the design department's point of view. Where engineers
    Read More

Highlighted Content