Tunnel for Macedonia capital

A new 1km long tunnel is being planned to help reduce congestion in Skopje, capital of Macedonia. The tunnel will be built by Turkish contractor Limak. The contractor will also build its own commercial development above the tunnel as part of the agreement. The cost of the tunnel project is not available at this point.
June 19, 2012 Read time: 1 min
A new 1km long tunnel is being planned to help reduce congestion in Skopje, capital of Macedonia. The tunnel will be built by Turkish contractor 5095 Limak. The contractor will also build its own commercial development above the tunnel as part of the agreement. The cost of the tunnel project is not available at this point.
Road Structures

For more information on companies in this article

Related Content

  • Huge investment for Moscow’s motorway routes
    May 1, 2015
    Huge investments being made in building several outbound routes in Moscow and the Moscow region – Eugene Gerden writes. Up to US$20 billion (900 billion Roubles) will be invested in the building of several outbound routes in Moscow and the Moscow region during the next few years, according to an official spokesperson of the Russian Ministry of Transport. It is planned that the routes will be built as flyovers above the railroad tracks in the Yaroslavl, Kazan, Riga and Paveletskaya directions of the
    Read More
  • Tajikistan tunnel repair work
    February 11, 2021
    Repair work is planned for Tajikistan’s Istiqlol tunnel.
    Read More
  • Turkish tunnel being built
    November 29, 2016
    The New Zigana Tunnel project in Turkey is currently under construction and is expected to cost up to US$1 billion in all. When complete this tunnel will measure an impressive 14.5km long. The two lane tunnel will connect Gumushane and Trabzon in the country’s north east, and will be located at an altitude of over 1,200m above sea level. The construction of the tunnel will replace the existing route over the Zigana Pass, which reaches an altitude above sea level of 2,032m. Once complete the new tunnel under
    Read More
  • Asphalt milling optimised by 3D controls
    February 20, 2012
    3D machine controls can optimise milling efficiency, Mike Woof reports. More efficient milling and recycling operations can be carried out by using the latest 3D control systems on the market. At the last Trimble Dimensions event in Las Vegas, the advantages of 3D controls for milling operations proved a key topic. The use of 3D control systems can offer huge advantages in milling operations. This technology helps increase productivity as the milling machine will only remove what is required, which also hel
    Read More

Highlighted Content