Skip to main content

Sweden and Denmark consider link between Helsingør and Helsingborg

Sweden and Denmark are considering a fixed link between Helsingør and Helsingborg, either a a road, railway or road-rail. The link would cross The Øresund, a straight separating the two countries that is only 6.7km wide between the Danish city of Helsingør and the Swedish city of Helsingborg. Investigations, likely to cost around €2.3 million including €1 million from the European Union, will start this month with a final report by 2020.
July 2, 2018 Read time: 2 mins
A Helsingør to Helsingborg bridge could take traffic off the Øresund bridge (pictured) that opened in 2000
Sweden and Denmark are considering a fixed link between Helsingør and Helsingborg, either a a road, railway or road-rail.


The link would cross The Øresund, a straight separating the two countries that is only 6.7km wide between the Danish city of Helsingør and the Swedish city of Helsingborg.

Investigations, likely to cost around €2.3 million including €1 million from the European Union, will start this month with a final report by 2020.

The completion in 2000 of the Øresund Bridge to the south, linking Copenhagen and Malmö, lessened the importance of Helsingør and Helsingborg ferry link but they ships still operate almost non-stop on this short route. The vessels carry man foot-passengers looking for days out in the two cities. For many drivers the ferry crossing saves driving distance compared to using The Øresund toll bridge.

Helsingør, known in English as Elsinore, has a population of around 62,000 and lies 45kkm from the capital Copenhagen. The city’s Kronborg castle is believed to have been the template for the setting of Hamlet by William Shakespeare.

Helsingborg, with a population of around 140,00, lies 555km to the south of the Swedish capital Stockholm.

The Øresund – a road and rail structure - runs along an 8km cable-stayed bridge to an artificial island where it then enters a 4km-long tunnel. It features two 204m-high pylons supporting the 490m-long bridge span across the Flinte Channel. The motorway runs on the upper level while the railway runs underneath.

Most bridge structures including the piers and spans were built on land and towed into position on barges. Only the pylons were cast in situ. The Øresund is operated by both countries and was designed by Danish engineering firm 2349 COWI along with main architect George KS Rotne.

For more information on companies in this article

Related Content

  • Historic bridge upgrade in Minneapolis
    July 28, 2022
    A historic bridge upgrade in Minneapolis is close to completion.
  • Russia plans new bridges, tunnels in roads rebuild
    February 22, 2012
    Russia plans to invest US$2.16 billion over the coming three years in rebuilding federal highways running through the Central Federal District.
  • European electric vehicle charging network
    December 17, 2014
    A new co-funded European project will provide fast-charging facilities for electric vehicles along major routes across the EU. The Trans-European Transport Networks (TEN-T) project is named the European Long-distance Electric Clean Transport Road Infrastructure Corridor (ELECTRIC). The project will see the installation of a corridor of high-quality fast chargers along key European highways by the end of 2015. The project should boost electric vehicle uptake in the involved Member States and focus on interop
  • New Wear Crossing cables fully installed and tensioned to 50%
    September 21, 2017
    Structural engineering company VSL International has installed all 28 cable stays of England’s New Wear Crossing and stressed them to 50% of their design load. The next stage of stressing the cables will happen next month and be to 100% of design load. This will allow the construction team to adjust and tension them just enough to lift the bridge deck off the blue steel temporary supports that were constructed in the river to take the weight of the structure.