Strabag’s Züblin subsidiary wins key A 100 Berlin urban motorway contract

Strabag subsidiary Züblin has been awarded the €73 million contract to build a 700 metre section of the A 100 urban motorway in Berlin, Germany. Situated at Sonnenallee Junction, the works will see Züblin not only construct a new dual-track commuter rail bridge and a single-track long-distance railway bridge, each with 68m spans; but also set up diaphragm walls, establish underwater concrete floors, install uplift and pit lining anchors, and drive the sheet piling and bored piles. The contract also encomp
May 28, 2014 Read time: 1 min
945 Strabag subsidiary Züblin has been awarded the €73 million contract to build a 700 metre section of the A 100 urban motorway in Berlin, Germany.

Situated at Sonnenallee Junction, the works will see Züblin not only construct a new dual-track commuter rail bridge and a single-track long-distance railway bridge, each with 68m spans; but also set up diaphragm walls, establish underwater concrete floors, install uplift and pit lining anchors, and drive the sheet piling and bored piles. The contract also encompasses the delivery and installation of 200,000m³ of concrete.

The works, which have already begun and are expected to last until August 2017, will be carried out with no interruption to rail service, necessitating the construction of several auxiliary bridges.

“This challenging construction order requires the extensive know-how of our ground engineering team,” said Thomas Birtel, CEO of Strabag.
Road Structures

For more information on companies in this article

Related Content

  • Highway project in Texas required demolition equipment
    May 1, 2018
    A contractor in Texas has used equipment from Brokk to help out with a tricky highway project. Upgrading work has been carried out on a 6.4km-long stretch of I-35 in San Antonio between Loop 410 NE and Loop 410 S. This stretch of the route was carrying around 185,000 vehicles/day and was suffering increasing levels of congestion at peak periods. Travel times lengthened by 65% during rush hour, while ramps on opposite sides of the interstate caused additional congestion and safety issues. In one section, t
    Read More
  • Bridge project uses high performing formwork
    February 20, 2012
    Doka designed and supplied a high-performing formwork technology solution for a challenging bridge project south of the German town of Halle. The 8,614m long single-cell box girder superstructure of the Saale-Elster Viaduct, with a typical cross section width of 13.9m, is borne on 220 piers, and has a constructional depth of 4m. It is mainly being erected on launching girders to minimise the impact on flora and fauna.
    Read More
  • Peri delivers formwork for Fehmarnbelt Tunnel
    July 12, 2023
    The last of the 12 ships delivering Peri’s formwork recently arrived at the tunnel element factory east of Rødbyhavn on Denmark’s Lolland island.
    Read More
  • Qatar tunnel project benefits from sophisticated formwork
    March 7, 2018
    A sophisticated formwork solution has played an important part in the construction of a new road and rail tunnel in Qatar in the Middle East. The formwork system was supplied by ULMA, which supplied its equipment for the construction of the Lusail Boulevard Tunnel in Qatar. The new tunnel provides access to the new Lusail City Development, from the heart of Doha and will be a vital transport link for the planned 2022 FIFA World Cup tournament. The overall Lusail City Development, located 15km north of Do
    Read More

Highlighted Content