Michael Baker receives authority to fly unmanned aerial systems

US-based engineering firm Michael Baker International has received certification from the Federal Aviation Administration to operate several types of fixed-wing and vertical take-off and landing unmanned aircraft systems. The company said its UAS can capture robust, real-time aerial photographs and video as well as conduct aerial mapping for surveys or site inspections. "Integrating our FAA-certified unmanned aircraft program with our other advanced data collection capabilities allows us to take data
August 17, 2015 Read time: 2 mins
US-based engineering firm Michael Baker International has received certification from the 2423 Federal Aviation Administration to operate several types of fixed-wing and vertical take-off and landing unmanned aircraft systems.

The company said its UAS can capture robust, real-time aerial photographs and video as well as conduct aerial mapping for surveys or site inspections.

"Integrating our FAA-certified unmanned aircraft program with our other advanced data collection capabilities allows us to take data collection to an entirely new level for our clients,” said Robert Hanson, senior vice president and the firm's Geospatial Practice leader.

"Our UAS capability builds upon the company's full continuum of innovative solutions that immediately enhance timeframes for planning and executing projects in surface transportation, utilities infrastructure, land development, pipelines and many other markets."

Vehicle operators can adjust still and video cameras on the aircraft to capture images at almost any angle. This enhances the quality of data captured from the same geographic location at different points in time.

According to the company, clients need fewer additional studies or surveys of a project because the UAS data provides a much fuller picture of a site or a building.

Connected Construction

For more information on companies in this article

Related Content

  • UK trialling hazard warning technology
    November 26, 2024
    Results from a project by the UK’s department of transport and AECOM – using Heads-Up technology from Acusensus, has underlined scale of distracted driving and lack of seatbelt use.
    Read More
  • Stantec to acquire consultants ENTRAN
    April 30, 2012
    North American design company Stantec has signed a letter of intent to acquire Lexington, Kentucky, USA-based ENTRAN, a 115-person transportation consulting company that also has offices in Chicago, Illinois; Cincinnati, Ohio; Charleston, West Virginia; Louisville, Kentucky; and Nashville, Tennessee.Stantec anticipates the close of the transaction in October, 2011.
    Read More
  • Airport runway rebuild at Bologna
    May 15, 2019
    Rebuilding a runway requires special attention to detail to maximise efficiency and safety Airport runways face special challenges with regard to the loads they carry on a daily basis, particularly when aircraft are landing. A modern jet aircraft will typically land at speeds of around 240-260km/h, with a laden 747 weighing as much as 265tonnes at the end of a long flight. The stresses these large aircraft place on runway surfaces are enormous and not just with the massive impact forces exerted during
    Read More
  • Bomag is on track – London to Glasgow in 2 hours and 40 minutes
    July 1, 2022
    British Railways has big plans. Trains on the first 220 km from London Euston Station to Birmingham could be travelling at a speed of 360 km/h (225 mph) in as little as 10 years. The earthworks required for this are to be completed by as early as 2025. The project is considered one of the largest and most ambitious infrastructure projects in recent British history. It must meet the highest possible construction quality standards and evolve over the course of the project - setting new standards today and for tomorrow. The deployment of innovative BOMAG technologies and machines is therefore logical and consistent.
    Read More

Highlighted Content