Machine autonomy for compactors and dozers being developed by Trimble

Trimble is working on innovative technologies that could revolutionise the construction and aggregates production sectors. Perhaps the most eye-catching of all of these is for the autonomous compactor and dozer system Trimble is in the process of developing. Scott Crozier is general manager of Trimble’s general construction division. He said that while this autonomous machine technology is not yet ready for the market, “It may not be as far away as expected.”
December 10, 2018 Read time: 2 mins

2122 Trimble is working on innovative technologies that could revolutionise the construction and aggregates production sectors.

Perhaps the most eye-catching of all of these is for the autonomous compactor and dozer system Trimble is in the process of developing.

Scott Crozier is general manager of Trimble’s general construction division. He said that while this autonomous machine technology is not yet ready for the market, “It may not be as far away as expected.”

Trimble still has a lot of development work to carry out on its autonomous machine control package and there will be other challenges too. He said, “There will be some regulations we’ll have to comply with.”

However the firm is confident that the project will deliver practical solutions and Crozier continued, “It’ll come in gradually.” He added that certain elements of the technology will be brought to market in the near future. Semi-autonomous technology could be on the market by 2020, with autonomous machines then being introduced for certain applications within five years.

The technology is being aimed at a particular range of duties. Crozier explained that these systems could be used in large greenfield construction sites such as for new airports or for use at landfill sites, where equipment would typically carry out repetitive operations. Geofencing would ensure that the machines would run in controlled areas away from personnel, optimising safety.

Connected Construction

For more information on companies in this article

Related Content

  • Bertha ends her Alaskan Way voyage in Seattle
    December 21, 2017
    Seattle's State Route 99 viaduct is coming down. David Arminas was on site. Bertha, the world’s largest diameter earth pressure balance tunnel boring machine, with a cutterhead diameter of 17.5m, is no more. Her 2.7km journey underneath the waterfront area of Seattle finished on April 4 and the power went off for the last time on an extraordinary TBM that had finally completed an extraordinary job. “A small sidewalk job would have had more impact on city traffic than we have had,” says Brian Russell a v
    Read More
  • Plain sailing for Caterpillar’s PM 300 series
    February 22, 2019
    Caterpillar’s revamped small cold planers have upped the stakes in the urban refurbishing market. World Highways deputy editor David Arminas recently caught up with A.J. Lee, global segment manager, on Spain’s Costa del Sol
    Read More
  • Researchers trial 3D printing for both concrete and asphalt roads
    February 27, 2019
    Automated road repairs, using 3D printing, could save money and vastly reduce disruption, and researchers are already showing it’s possible - Kristina Smith reports It’s the middle of the night, and in the street below a team is busy carrying out repairs to the road surface. But there isn’t a human in sight. A road repair drone has landed at the site of a crack and a 3D asphalt printer is now busy filling in that crack. A group of traffic cone drones have positioned themselves around the repair location
    Read More
  • Construction adapting with Machine control Technologies
    June 18, 2015
    Machine control technologies are revolutionising construction – Dan Gilkes writes Electronic control of engines, transmissions and hydraulic systems, primarily to reduce exhaust emissions and boost productivity, is also providing manufacturers with an opportunity to incorporate increasingly complex machine control into their equipment. This in turn has the potential to make the machinery more productive, further cutting fuel consumption as part of a virtuous operational circle.
    Read More

Highlighted Content