Skip to main content

VIDEO: Successful explosive bridge demolition in Kentucky

July 28, 2016
A successful explosive bridge demolition job has been carried out in the US State of Kentucky. After a short delay, demolition specialists managed to remove the old Eggners Ferry Bridge successfully and without incident. The explosives broke up the four middle spans of the structure. The demolition job was not without its challenges, with concern over the presence of nesting ospreys on the structure. Demolition personnel had to keep a distance of 90m from the nesting area, which delayed preparations.

The debris from the old structure is now being removed using a team of divers and crawler cranes mounted on barges.

The old two lane bridge was constructed in the early 1930s to connect Trigg and Marshall counties in Kentucky. It first opened to traffic in March 1932, carrying US 68 and Kentucky Route 80 across the Kentucky Lake although the bridge was closed between July 1943 and February 1944 to raise the height of the structure and add additional piling as support.

The old bridge suffered severe damage when it was struck by a vessel in early 2012, with one of the main spans collapsing into the river. Although there were vehicles crossing the bridge at the time, none fell into the river although one driver had a very close call. After repairs were made the bridge was reopened a few months later.

However, plans were already well in hand to build a new bridge, with work starting in 2011. This wider structure, with two lanes in either direction, was originally intended to open in 2017 but when the old bridge was damaged, the local authorities decided to speed up construction of the new US$133 million crossing.

Related Content

  • VIDEO: Bridge demolition jobs in CA
    November 23, 2015
    Explosive demolition techniques were used to remove a bridge structure in the US at the weekend. In California on the west coast, the removal of a pier from the old Bay Bridge structure was carried out. The explosive demolition was organised by 5246 Caltrans, with around 10tonnes of explosives being used to blast the redundant bridge pier. Protective layers of wood and steel were used to prevent debris from the massive 24.4m x 42.7m bridge pier from being thrown into the air.
  • Highway project in Texas required demolition equipment
    May 1, 2018
    A contractor in Texas has used equipment from Brokk to help out with a tricky highway project. Upgrading work has been carried out on a 6.4km-long stretch of I-35 in San Antonio between Loop 410 NE and Loop 410 S. This stretch of the route was carrying around 185,000 vehicles/day and was suffering increasing levels of congestion at peak periods. Travel times lengthened by 65% during rush hour, while ramps on opposite sides of the interstate caused additional congestion and safety issues. In one section, t
  • Ageing Liberty Tunnels in US refurbished with hydrodemolition
    May 13, 2015
    Hydrodemolition surface preparation keeps Liberty Tunnel rehabilitation project on schedule in Pittsburgh. The Pennsylvania state Department of Transportation selected hydrodemolition surface preparation for the US$18.8 million rehabilitation of Pittsburgh’s Liberty Tunnels. Time was of the essence to complete the project on deadline without penalties and hydrodemolition was selected as it offered a fast and cost-effective method to prepare the tunnel walls for a new, shotcrete surface. This methods off
  • The Mersey Gateway bridge project continues on schedule
    October 18, 2016
    Work continues on the 2.3km Mersey Gateway signature bridge project close to Liverpool in the UK. David Arminas reports on some of the construction highlights. Under construction is a cable-stayed structure with three towers that will span the Mersey River’s expansive mud flats between the towns of Runcorn and Widnes near Liverpool. Including the approach viaducts on each side, it will be 2.3km long with a river span of 1km. The main bridge deck will be reinforced concrete. The 80m-high central tower will b