Roadtec RX-600eLR miller cuts flush to left and the right

April 15, 2016

Astec has brought its new Roadtec RX-600eLR half-lane milling machine to bauma 2016. Able to cut flush on the left and the right hand side of the road, the RX-600eLR offers contractors a 2m-wide, 60cm-deep cutter and a drum driven by two hydrostatic motors, one mounted on either side of the machine.

Exhibitions

bauma 2016

Related Content

Major Necaxa-Tihuatlan Highway project for Mexico

October 1, 2014

A new highway in Mexico is connecting Necaxa with Tihuatlan and the project features challenging terrain - Mauro Nogarin reports In Mexico a landmark highway project is now close to completion, having set a number of records for Latin America.

Read More
New milling machine from Bomag

November 24, 2021

Bomag is launching its new BM/65 series of cold planers

Read More
Highway project in Texas required demolition equipment

May 1, 2018

A contractor in Texas has used equipment from Brokk to help out with a tricky highway project. Upgrading work has been carried out on a 6.4km-long stretch of I-35 in San Antonio between Loop 410 NE and Loop 410 S. This stretch of the route was carrying around 185,000 vehicles/day and was suffering increasing levels of congestion at peak periods. Travel times lengthened by 65% during rush hour, while ramps on opposite sides of the interstate caused additional congestion and safety issues. In one section, t

Read More
Smoother surfaces

September 11, 2014

Efficient new soil compaction machines featuring the latest technology are now coming to market – Mike Woof reports The start of 2014 has seen a major development for the construction equipment sector, with the Tier 4 Final emissions requirements at last beginning to take effect. The implications of the drive towards the introduction of low emission engine technology have been seen right across the off-highway machinery equipment industry, and the soil compaction segment is no exception.

Read More