Roadtec RX-600eLR miller cuts flush to left and the right

April 15, 2016

Astec has brought its new Roadtec RX-600eLR half-lane milling machine to bauma 2016. Able to cut flush on the left and the right hand side of the road, the RX-600eLR offers contractors a 2m-wide, 60cm-deep cutter and a drum driven by two hydrostatic motors, one mounted on either side of the machine.

Exhibitions

Related Content

  • Milling versatility on German road job
    March 22, 2017
    Milling efficiently with a versatile, mid-sized machine has offered benefits on a German road job. A German contractor has found that using a mid-sized milling machine from Wirtgen has offered a good combination of both versatility and productivity for a road rebuild job. Kassel-based milling specialist VORO has used a Wirtgen W 100 CFi to upgrade the surface of a section of the busy B3 route. The B3 is an important route and runs 755km from Buxtehude in the north of Germany through to the Swiss border in t
    Read More
  • Deep and wide with Wirtgen’s W 100 CFi compact milling machine
    May 14, 2018
    The spread of fibre-optic cables, especially for broadband internet access, is advancing rapidly across the world. The Upper Austrian district of Schärding, not far from the German border, is no exception. Engelhartszell is the second community to benefit from this technology. And the contractor, Hemmelmair Frästechnik from Linz, is also making use of cutting-edge technology - in this case made from steel and carbide. A Wirtgen W 100 CFi compact milling machine with deep milling unit is being used for tren
    Read More
  • Westquay offers Tesmec trencher
    February 7, 2012
    Westquay Trading, the UK dealer for Tesmec, has introduced a new mini trencher designed for compact utilities and specialist plant hire for highways across the UK. The new TRS300 mini trencher weighs in at 9,500kg, and says Westquay Trading, at 180cm wide and 285cm high meets the growing demand for a compact sized machine, capable of high productivity cable trenching for highways, built-up areas and streetworks. The TRS300 provides a remote control system for complete trench cutting and cable laying, which
    Read More
  • A Wirtgen W 100 CFi mills about in Austria
    December 15, 2017
    In Austria, a Wirtgen W 100 CFi compact milling machine with deep milling unit is being used for trenching prior to the laying of broadband cables – just before it sets to work milling off entire pavements. Work is being done in Engelhartszell in the Upper Austrian district of Schärding, not far from the German border. Contractor Hemmelmair Frästechnik, from Linz, is making use of the W 100 CFi’s cutting-edge technology, in this case made from steel and carbide.
    Read More

Highlighted Content