Roadtec RX-600eLR miller cuts flush to left and the right

April 15, 2016

Astec has brought its new Roadtec RX-600eLR half-lane milling machine to bauma 2016. Able to cut flush on the left and the right hand side of the road, the RX-600eLR offers contractors a 2m-wide, 60cm-deep cutter and a drum driven by two hydrostatic motors, one mounted on either side of the machine.

Exhibitions

Related Content

  • Atlanta airport’s new apron
    October 12, 2012
    The new Maynard H Jackson Jr International Terminal at Hartsfield- Jackson Atlanta International Airport is now open for business. The 111,484m2 terminal features 12 gates, eight security checkpoints, separate levels for arrivals and departures, as well as a 148,831m2 concrete apron for aircraft to park on arrival. Archer Western won the contract to slipform the concrete apron, replace the existing Taxiway D, as well as other utilities and embankment work. The firm brought in one of its GOMACO paving trains
    Read More
  • Dynapac planer improves racing line
    July 30, 2012
    A Dynapac PL350T cold planer helped carry out critical demarcation work on the roads used for the famous Isle of Man's TT motorcycle races. It was used to remove the road markings on the isle in the Irish Sea in readiness for the races. The Dynapac machine is equipped with a special micro milling drum which contains 117 bits, compared to the standard 38, spaced at intervals of 3mm as opposed to the conventional 12mm. In addition, to avoid a sharp edge at the sides of the demarcation area, the drum is slight
    Read More
  • Epiroc V Cutter range grows
    July 25, 2022
    Epiroc is adding new models to its V Cutter range, after it launched the V-shaped drum cutter for trenching and quarrying recently. The company describes the V Cutter as a new way to work with rock, concrete wall and surface profiling, trenching, soft rock excavation, frozen soil excavation, and demolition.
    Read More
  • Upright performance from the RW 500 wheel saw from Simex
    April 26, 2018
    Simex has continued with design refinements of the RW 500 wheel saw with the introduction of the RWA 500. The RWA 500 operates constantly perpendicular to the surface, even when the prime mover, a skidsteer wheeled loader, is at a slant. The RWA 500’s high productivity is a result of hydraulic piston motors in direct drive with the milling disk, which delivers maximum efficiency and a large cutting force. Operators are assured good visibility because the excavation depth corresponds exactly and
    Read More

Highlighted Content