Tilting Sensed

Tilting sensed Rugged inclinometers and tilt sensors are offered by Axiomatic, which has a series of new low cost units that can measure ±90º degrees or 360 degrees angular rotation. The angles are measured by a two-axis MEMS sensor, which senses acceleration caused by gravity. In a tilt sensor application, an out-of-range state can be transmitted as one of its outputs. The latest AX06025X series features CANopen networking, an RS-232 port or three Voltage outputs for communicating the angular measurement.
February 6, 2012 Read time: 2 mins
Axiomatic says that its rugged tilt sensors suit duties on earthmoving machines such as elevators
Tilting sensed Rugged inclinometers and tilt sensors are offered by 1532 Axiomatic, which has a series of new low cost units that can measure ±90º degrees or 360 degrees angular rotation. The angles are measured by a two-axis MEMS sensor, which senses acceleration caused by gravity. In a tilt sensor application, an out-of-range state can be transmitted as one of its outputs.

The latest AX06025X series features CANopen networking, an RS-232 port or three Voltage outputs for communicating the angular measurement. The inclinometer series also supports the SAE J1939 CAN interface under the p/n's AX0602XX. The J1939 inclinometer is fully configurable using the Axiomatic Electronic Assistant programming tool for PCs. All units are packaged for an IP67 rating with M12x2 5-pin connectors or M12 x1 5-pin. The inclinometer is designed to measure inclination angle in two orthogonal sensing directions X and Y in the range of up to ±90º. If vertically installed, it can measure an inclination angle in one sensing direction in the ±180º (0-360º) range.

For more information on companies in this article

Related Content

  • Loading and hauling machine improvements will boost quarry production
    July 4, 2014
    Major advances are being seen in the market for loading and hauling machines, with manufacturers developing new solutions for the quarry segment in particular- Mike Woof writes Wheeled loaders and rigid chassis dump trucks are key movers in many quarry operations. New develop-ments have seen the introduction of several new models from key players.
    Read More
  • On-site computing power
    August 2, 2012
    Leica Geosystems is expanding its range with the launch of its Leica DX10 Field Controller. This robust site PDA is designed specifically for use in the tough construction environment, is compact, versatile and powerful. The Leica DX10 delivers high performance and reliability and can cope with vibration, shock and temperature extremes. It features an ergonomically shaped case and weighs just 482grammes. Features include Bluetooth capabilities, a high contrast colour display, a 520MHz Intel Xscale processor
    Read More
  • Commander shows versatility for GOMACO
    March 10, 2017
    GOMACO is offering a new solution for concrete slipforming at CONEXPO-CON/AGG 2017. The firm is increasing the versatility of its Commander III slipformer further with the development of the next generation machine and now offers it in three- as well as the original four-track configuration. The new three-track Commander IIIx has three tracks and can also be equipped with latest generation telematics technology.
    Read More
  • Rapid adoption of GPS machine control
    April 5, 2012
    The high sophistication of GPS machine control systems has resulted in a fast pace of technological advancement. The three major players in the machine control sector, Leica Geosystems, Topcon and Trimble have all made major gains in recent years. The sophistication of the latest systems can combine satellite position data from the GPS and GLONASS networks with information from total stations to provide precise, high speed machine operation. Further more the firms have also prepared themselves for the intro
    Read More

Highlighted Content