Tilting Sensed

Tilting sensed Rugged inclinometers and tilt sensors are offered by Axiomatic, which has a series of new low cost units that can measure ±90º degrees or 360 degrees angular rotation. The angles are measured by a two-axis MEMS sensor, which senses acceleration caused by gravity. In a tilt sensor application, an out-of-range state can be transmitted as one of its outputs. The latest AX06025X series features CANopen networking, an RS-232 port or three Voltage outputs for communicating the angular measurement.
February 6, 2012 Read time: 2 mins
Axiomatic says that its rugged tilt sensors suit duties on earthmoving machines such as elevators
Tilting sensed Rugged inclinometers and tilt sensors are offered by 1532 Axiomatic, which has a series of new low cost units that can measure ±90º degrees or 360 degrees angular rotation. The angles are measured by a two-axis MEMS sensor, which senses acceleration caused by gravity. In a tilt sensor application, an out-of-range state can be transmitted as one of its outputs.

The latest AX06025X series features CANopen networking, an RS-232 port or three Voltage outputs for communicating the angular measurement. The inclinometer series also supports the SAE J1939 CAN interface under the p/n's AX0602XX. The J1939 inclinometer is fully configurable using the Axiomatic Electronic Assistant programming tool for PCs. All units are packaged for an IP67 rating with M12x2 5-pin connectors or M12 x1 5-pin. The inclinometer is designed to measure inclination angle in two orthogonal sensing directions X and Y in the range of up to ±90º. If vertically installed, it can measure an inclination angle in one sensing direction in the ±180º (0-360º) range.

For more information on companies in this article

Related Content

  • Out of sight
    July 16, 2012
    With traffic volumes increasing around the world, many existing road links will need to be upgraded or replaced in coming years The need for new road tunnels is particularly intense in many dense urban areas, due to environmental requirements that mean new road links will have to be installed underground. However, improving existing road tunnel links is providing a very large part of the business for this specialised construction segment at present.
    Read More
  • The use of telematics in construction machines is growing
    May 20, 2015
    Demand for telematics technology is growing, as equipment users begin to lean the value of these systems – Alan Dron reports With construction projects increasingly operating to wafer-thin profit margins, any technological assistance that can keep the accounts in the black is welcome. This is particularly the case with those projects where contractors can share a larger slice of the profits if they complete their work ahead of schedule. The downside, of course, is that they also share the pain if the
    Read More
  • Florida gets one.network closure
    November 14, 2022
    Road crews in the US state of Florida can now post lane closure information to GPS providers from their mobile phones while working on site
    Read More
  • Engcon's powerful new EC233 tiltrotator and Trimble guidance
    June 3, 2019
    Engcon has announced that the company’s new EC233 series tiltrotator is in full production. According to the Swedish manufacturer, the EC233, with a break torque of 340kNm, will be the market's most powerful tiltrotator for excavators between 24-33tonnes. The EC233 replaces Engcon’s EC30, which has been in production since the mid 1990's, notes Robert Hunt, managing director of Engcon UK. The product development cycle was focused on destructive tests where both mountings and connectors were exposed to
    Read More

Highlighted Content