Skip to main content

Russian road repair

The driver of a construction truck in the Russian city of Voronezh recently had an unwelcome surprise when his own vehicle became the centre for a major road repair. The mixer truck was being driven along the road to a construction site when it suddenly fell into a large hole in the roadway. No ordinary pothole, this was sufficiently large for the rear of the vehicle to tumble inside, leaving only the cab poking out. The driver managed to jump out and was unhurt. The truck was less fortunate however as the
January 14, 2015 Read time: 2 mins
The driver of a construction truck in the Russian city of Voronezh recently had an unwelcome surprise when his own vehicle became the centre for a major road repair. The mixer truck was being driven along the road to a construction site when it suddenly fell into a large hole in the roadway. No ordinary pothole, this was sufficiently large for the rear of the vehicle to tumble inside, leaving only the cab poking out. The driver managed to jump out and was unhurt. The truck was less fortunate however as the mixer was stopped from rotating, which then allowed the concrete to set hard. It took two days for the truck to be removed from the massive hole in the roadway due to the difficulty of extracting the heavy vehicle, made worse by concerns that a further section of the roadway could collapse. The incident caused major traffic congestion in the city as well as calls for an investigation into as to why the road could have collapsed, considering that it had been repaired only shortly beforehand.

Related Content

  • Airport's high demands on asphalt and concrete techniques
    July 11, 2012
    Airport runway, taxiway and parking areas make high demands on paving requirements, both with concrete and asphalt techniques. Mike Woof reports. High quality surface finishes are required in airport environments for runways, taxiways and aircraft parking areas. Because of the speed at which aircraft take off and land and the massive forces exerted due to the weight of the aircraft, particularly during landing, runway structures need to be incredibly strong. The surfaces also have to be constructed to very
  • Concern over poor US road safety
    September 20, 2021
    There is growing concern over poor US road safety.
  • Rebuilding better gravel roads more efficiently
    October 15, 2015
    Using a linear road crusher can rebuild gravel roads using material onsite at a fraction of the cost of conventional methods. Gravel roads are common in many rural areas in the US to provide access to temporary work sites and are also used widely in developing countries. Maintaining and repairing these roads can pose challenges and new methods may offer improvements in efficiency.
  • Accurate weigh-in-motion technology
    June 21, 2016
    Weigh-in-motion technology is ensuring increasingly accurate, and flexible, weighing stations. Weigh-in-motion specialist manufacturer Axtec says that its space-saving dynamic weighbridge is accurate to within ±0.5% and is the most precise system in the world. From its Runcorn, UK manufacturing facility, Axtec undertakes research and development of new technologies, as well as software testing, fabrication, construction and installation of WIM products. Axtec’s axle weighing platform design is intended f