RexPactor delivers single pass compaction with offset wheels

CMI Roadbuilding has launched a three-model Rexpactor compaction line-up at CONEXPO-CON/AGG in response to previous customer requests. The updated RexPactor compaction machines have a four-wheel design, however the two front wheels are close together, inside the line of the rear wheels.
March 8, 2017 Read time: 1 min
Offset four-wheel design delivers single pass compaction

8591 CMI Roadbuilding has launched a three-model Rexpactor compaction line-up at CONEXPO-CON/AGG in response to previous customer requests. The updated RexPactor compaction machines have a four-wheel design, however the two front wheels are close together, inside the line of the rear wheels. This design ensures that all four wheels compact a different line, in effect delivering full-width compaction in a single pass. This layout also ensures that the machine can’t become bogged down with uncompacted material between the wheels.

There are three models available: the 17.2 tonne SP-3; the 22.7 tonne SP-5 and the 33 tonne SP-8. They deliver a distributed load of 81,156Nm, 91,212Nm and 99,877Nm respectively using an open-ring wheel design, rather than a solid padfoot roller wheel. Bottom-up compaction is achieved by forcing the wheel rings to sink into the soil under static weight.

The RexPactor range is designed for use in road construction, pipelines and other soil embankment construction. All three models can be supplied with a standard semi-U blade or with an optional tilt blade.

For more information on companies in this article

Related Content

  • Increased performance from hand-operated compaction machines
    March 14, 2012
    Compact compaction units are delivering increased performance – Mike Woof reports. Competition is tough in the market for non-ride-on compaction units, with two manufacturers now introducing revamped models. Both JCB and Wacker Neuson aim to claim a larger section of the market with their latest designs, compaction plates and remote-controlled trench rollers respectively.
    Read More
  • New soil compactors round out Atlas Copco’s range
    December 20, 2013
    Atlas Copco has completed the introduction of its fifth generation soil compactor range with the roll-out of the compact CA models. The new Dynapac CA1300 and CA1500 machines share features with the larger machines launched earlier this year, with a focus on reduced operating costs, low operating noise and fuel consumption and ease of servicing.
    Read More
  • Doka delivers cantilevering for super-slim piers at Lahntal Bridge
    October 21, 2016
    Doka’s formwork expertise is currently in demand during the construction of one of the busiest motorway viaducts in Germany. The 400m six-lane Lahntal Bridge in Limburg dates from the early 1960s. Every day about 100,000 vehicles cross the bridge that spans the valley of the River Lahn. But traffic loads have increased sharply, so a new bridge is being built sited just a few metres west of the old viaduct. The new Lahntal viaduct will measure a massive 43.5m in width, enabling eight lanes plus hard shoul
    Read More
  • Engine firms delivering innovative solutions for reducing emissions and fuel consumption
    January 6, 2017
    Solutions for Tier 4 Final emissions regulations dominated Conexpo 2014, with many firms showing off their options of DOC, DPF and SCR after-treatments. Deutz, while staying with an SCR-only solution, took a more unusual approach on its high horsepower V6 12litre and V8 16litre engines. Both get a dual SCR after treatment system to meet Tier 4 Final emission standards.
    Read More

Highlighted Content