Improved transport for Kobelco Construction Machinery’s demolition boom

The challenge of transporting the front-end equipment of high-reach demolition-spec excavators has been a key driver in the development of Kobelco Construction Machinery’s latest models, the 40tonne SK400D and 55tonne SK550D. Both offer working heights of 25m and 28m respectively from a three-piece boom.
April 25, 2018 Read time: 1 min
Kobelco’s latest demolition boom uses a redesigned intermediate section to reduce its transport height.
The challenge of transporting the front-end equipment of high-reach demolition-spec excavators has been a key driver in the development of 2200 Kobelco Construction Machinery’s latest models, the 40tonne SK400D and 55tonne SK550D. Both offer working heights of 25m and 28m respectively from a three-piece boom.


It is the intermediate boom section that has undergone a redesign, which now benefits from revised hydraulic cylinder positioning. By overlapping the cylinders in a X-pattern, engineers have found a way to fold the boom more tightly than before. This also combines with a much shorter intermediate boom piece, and the resulting transport height falls below two metres.

The firm said that this reduced overall height of the folded boom avoids the need for a specialist low-deck trailer system when getting the machines ready for transport.

For more information on companies in this article

Related Content

  • Airport runway rebuild at Bologna
    May 15, 2019
    Rebuilding a runway requires special attention to detail to maximise efficiency and safety Airport runways face special challenges with regard to the loads they carry on a daily basis, particularly when aircraft are landing. A modern jet aircraft will typically land at speeds of around 240-260km/h, with a laden 747 weighing as much as 265tonnes at the end of a long flight. The stresses these large aircraft place on runway surfaces are enormous and not just with the massive impact forces exerted during
    Read More
  • Machine control helps with earthquake reconstruction
    December 4, 2014
    In Japan the latest machine control technologies are being used to help with earthquake reconstruction. Three years after the major earthquake that devastated Miyagi Prefecture on Japan’s main island of Honshu, the clean-up and reconstruction work is far from complete. In addition to rebuilding infrastructure and buildings, the Japanese Government has had to build a series of major improvements to flood protection.
    Read More
  • Technology helps earth moving and paving
    August 18, 2014
    Located in Meeker, Colorado and serving the area for air transportation is Meeker Airport, a C-II general aviation airport. The FAA designation of C-II means the airport can accommodate aircraft with wingspan of less than 24m. Runway 3-21 at the Rio Blanco county-owned Meeker Airport had reached a point of wear and deterioration that required full reconstruction and upgrades to remain compliant with the FAA’s C-II requirements.
    Read More
  • RMD Kwikform 3D viaduct design aids single concrete pour in Norway
    March 13, 2015
    Engineers with RMD Kwikform used 3D modelling to overcome challenging terrain and tight schedules for pouring a single-deck concrete viaduct in mid-Norway. The Doro Viaduct is a post-tension three-span single-carriageway measuring 9.5m wide. It forms an important part of the large realignment of the E39 Harangen-Høgkjølen route in the Trondheim mid-region of Norway. The project needed a formwork and shoring solution to support a 93m-long, 750m3 single-deck pour for the three span Doro viaduct in Norway. For
    Read More

Highlighted Content