Skip to main content

Improved pedestrian safety in Qatar

Improved pedestrian safety is being achieved in Qatar with the help of new technology. AGD Systems and Qatar-based Traffic Tech Group have joined forces to install pedestrian detection systems. Traffic Tech Group will be AGD’s exclusive global distributor for the Puffin and Toucan pedestrian crossings in the region to increase pedestrian and cyclist safety and improve traffic flows. On-street trials of AGD-enabled Puffin and Toucan schemes commenced in late 2014 at a dual pedestrian crossing on the busy A
July 14, 2015 Read time: 2 mins
The new crossing systems will boost pedestrian flows in Qatar
Improved pedestrian safety is being achieved in Qatar with the help of new technology. AGD Systems and Qatar-based 5456 Traffic Tech Group have joined forces to install pedestrian detection systems. Traffic Tech Group will be AGD’s exclusive global distributor for the Puffin and Toucan pedestrian crossings in the region to increase pedestrian and cyclist safety and improve traffic flows.

On-street trials of AGD-enabled Puffin and Toucan schemes commenced in late 2014 at a dual pedestrian crossing on the busy Al-Jazeera Al-Arabiya Road in Doha, Qatar. This installation has been successful and the schemes have now received approval from the Qatar Authority.

The Puffin crossings use a combination of nearside signals and pedestrian 'push-button' demand units with AGD 640 pedestrian detectors to automatically vary the length of the pedestrian period. This gives pedestrians the time they need to cross the road and if the pedestrian leaves the wait area, the demand is cancelled, freeing up the traffic.

AGD’s 226 radar continuously monitors the pedestrians when they are on the crossing, only allowing vehicle traffic signals to turn back to green once the crossing is completely clear. The fact that the system is detector-based ensures that waiting time for traffic is minimised while maintaining safety for vulnerable road users. This is in comparison to the traditional time-based systems that are still in use throughout the region.

For more information on companies in this article

Related Content

  • Efficient slipforming with Wirtgen
    May 15, 2019
    A Kentucky concrete slipforming contractor is benefiting from new technology in optimising kerb and gutter work. Fox Enterprises now constructs offset kerb, gutter and parking lot island placements using an on-site guidance system. The system permits automated placement of those items, including tight radii. Its fleet recently expanded to include a larger slipform paver that can handle offset curb-and-gutter paving, but also inset pavement slab paving.
  • Weigh in motion technology reduces road damage
    February 8, 2012
    Overweight vehicles cause enormous damage to road structures but they can be caught, even at high speed. Weigh-in-motion or WIM devices are designed to capture and record axle weights and gross vehicle weights as vehicles drive over a measurement site.
  • Airport runway rebuild at Bologna
    May 15, 2019
    Rebuilding a runway requires special attention to detail to maximise efficiency and safety Airport runways face special challenges with regard to the loads they carry on a daily basis, particularly when aircraft are landing. A modern jet aircraft will typically land at speeds of around 240-260km/h, with a laden 747 weighing as much as 265tonnes at the end of a long flight. The stresses these large aircraft place on runway surfaces are enormous and not just with the massive impact forces exerted during
  • Innovative traffic information technology used in Vancouver
    April 12, 2012
    As the world descended on Vancouver for the 2010 Winter Olympics, visitors were able to travel around the city with confidence and intelligence thanks to a landmark project by IRF Member, Delcan