Skip to main content

Highway delineator system aids crash reduction

A new delineator design is said to be helping to reduce accidents on a 200mile stretch of one of the world’s most treacherous highways. Pexco LLC has produced the ‘Dalton Delineator’ for the Dalton Highway, a remote 414mile road in Alaska, reported to be the sixth most dangerous roadway in the world. The road safety system has a cantilever structure consisting of a short length of a Davidson Flexi-Guide FG 400 Roadside Delineator post mounted to a special flexible coupler.
March 21, 2012 Read time: 2 mins
The Dalton Delineator aims to reduce crashes on one of world’s most dangerous highways
A new delineator design is said to be helping to reduce accidents on a 200mile stretch of one of the world’s most treacherous highways. 301 Pexco LLC has produced the ‘Dalton Delineator’ for the Dalton Highway, a remote 414mile road in Alaska, reported to be the sixth most dangerous roadway in the world.

The road safety system has a cantilever structure consisting of a short length of a Davidson Flexi-Guide FG 400 Roadside Delineator post mounted to a special flexible coupler. The polyurethane-made coupler is attached to a square steel tube support by the roadside. The delineator post, also known as an arm, projects horizontally out from the shoulder, above the roadway. The use of white delineator arms on one side of the road and green delineator arms on the opposite side, likened by Pexco LLC to the running lights on a boat, is said to give motorists and highways maintenance workers clear indication of their position on the road, even in the midst of a blinding snowstorm.

Half of all vehicle crashes on the Dalton Highway occur during daylight hours, while a quarter take place at night when drivers are travelling on non-lighted sections of the road.

The installation of the Dalton Delineator, which began in summer 2011, comes after Alaska DOT asked Pexco LLC in early 2009 to come up with new ideas to build on the success of its existing Dalton Highway FG 400 Roadside Delineator post.

For more information on companies in this article

Related Content

  • US road safety record
    April 26, 2012
    The latest official statistics from the US on road accidents show that fatality levels on the nation's roads have dropped to the lowest figures seen for more than six decades. The information was released by US Transportation Secretary Ray LaHood, revealing that highway deaths fell to 32,885 for 2010, the lowest level since 1949.
  • Road markings important for road safety
    February 20, 2012
    Manufacturers are constantly upgrading marking materials and equipment. Now those responsible for highways are being asked to do more as Patrick Smith reports. A recent report claimed that nearly one-third of the length of Britain's single carriageway A-roads have white lines so worn out that they do not meet recognised standards. According to the LifeLines Report, an assessment of more than 2,400km of the road network, Britain's most dangerous roads have the most worn-out centre line markings of all, leavi
  • Using ITS to maximise safety and traffic flow for cycling
    January 22, 2013
    Copenhagen, Denmark, has long been known as one of the world’s leading cities for cycling. In some areas of the city, the modal share of bikes has reached a level of as much as 50 %. And on some of the most frequently used bike paths the average daily number of cyclists is close to 30,000. As these numbers continue to rise, new ways of planning and implementing cycling infrastructure are needed. Increasingly, Danish traffic planners are turning to technology as a tool for planning cycling infrastructure. I
  • Stronger crash barriers may be needed for heavier trucks
    January 4, 2013
    The European Road Federation (ERF) has voiced its concern that roadside barriers in Europe may have to be upgraded According to the ERF, the recent decision of the European Commission to allow cross-border movement of longer and heavier trucks, it is keen to raise awareness of the important implications such a move may have for road barriers. ‘Road safety barriers are designed and tested according to the maximum weight of vehicles circulating on Europe’s roads. The current European Norm (EN 1317) allows for