Gill Instruments improves performance of 3-axis anemometers

Gill Instruments has improved the sonic temperature performance of the company’s 3-axis anemometer range to an accuracy of greater than ±1% in readings between -18°C and +30°C. The improvement has been achieved by using the US National Physical Laboratory’s advanced sound profiling facility as well as research using in-house computational fluid dynamics - CFD modelling - to examine transducer production. Anemometers are used throughout the meteorological research and industrial industries. They simultane
June 9, 2015 Read time: 2 mins
8134 Gill Instruments has improved the sonic temperature performance of the company’s 3-axis anemometer range to an accuracy of greater than ±1% in readings between -18°C and +30°C. The improvement has been achieved by using the US National Physical Laboratory’s advanced sound profiling facility as well as research using in-house computational fluid dynamics - CFD modelling - to examine transducer production.

Anemometers are used throughout the meteorological research and industrial industries. They simultaneously monitor turbulent fluctuations of wind and sonic temperature in order to accurately calculate sensible heat flux or wind load.

Gill claims the result is a generation of transducer assembly that benefits from small yet significant design changes to the assembly processes at the same time preserving the high performance of the existing transducer.

To maintain the integrity and continuity of the 3-axis anemometer range, Gill tightly controls the software, electronics, head geometry and transducer to ensure changes are limited to improving only the performance of sonic temperature.

“Gill 3-axis anemometers consistently outperform other sonic anemometers in the measurement of 3-dimensional wind vectors and sensible heat fluxes” said Gill’s product manager Richard McKay. “Now, following recent improvements, all Gill 3-axis anemometers can benefit from improved sonic temperature performance. A key advantage is that these improvements maintain the continuity of design and we now have high performance in all conditions”.

For more information on companies in this article

Related Content

  • Trimble is launching new machine control technology
    November 9, 2016
    Trimble is introducing a range of new technology options for customers that will boost working efficiency across a range of duties. The firm has also scored a major deal with one of China’s largest equipment manufacturers, XCMG.
    Read More
  • Winter maintenance challenge
    February 29, 2012
    Many countries had their most severe winter for years, but it could have been much worse without the right equipment and technology as Patrick Smith reports. As many countries faced up to the 2010-2011 winter, hard-pressed maintenance teams did their best to keep things moving on the roads. With some of the lowest temperatures and heaviest snowfalls on record, the UK, Republic of Ireland, Switzerland, France, Scandinavia, Germany, and Belgium were among those affected. Russia, eastern Europe and the USA did
    Read More
  • Caterpillar’s 313F excavator and M318 wheel loader shine in Spain
    May 19, 2015
    Caterpillar’s hallmark has been to stake its brand value on the ability to improve on products already considered very good. So it was with some pride that the global group unveiled its new 313F L GC tracked excavator during a dealer and media demonstration conference in Malaga, southern Spain in early March. The 313’s close cousin is the 312E, a high-use machine designed to put in long hours to maximise the owner’s productivity over the machine’s life cycle. The machine’s owner likely gets paid by the h
    Read More
  • Positioning tools continue to improve
    July 16, 2012
    Topcon says that its new IP-S2 package combines GNNS positioning capabilities with inertial sensors, while the firm also has a solution for customers wanting to mix and match receiver components. The IP-S2 is a vehicle-mounted, mobile 3D tool that offers precision mapping and surveying capabilities. The package collects data using 3D laser scanners, LIDAR, and/or cameras, and this is then integrated, time-stamped and geo-referenced. The customer can use this assembled data to combine LIDAR point cloud and d
    Read More

Highlighted Content