Skip to main content

Divine intervention?

An American man rammed his vehicle into a car being driven by a woman and later claimed he had done so under express instructions from God. The man crashed his pick-up truck into the woman's car while he was travelling at over 160km/h. His vehicle hit the rear of the car and both vehicles spun across a median then came to a stop along a barrier in the opposite lanes. Luckily the drivers suffered only minor injuries and police commented that this could have been a sign of divine intervention given the high s
February 24, 2012 Read time: 2 mins
An American man rammed his vehicle into a car being driven by a woman and later claimed he had done so under express instructions from God. The man crashed his pick-up truck into the woman's car while he was travelling at over 160km/h. His vehicle hit the rear of the car and both vehicles spun across a median then came to a stop along a barrier in the opposite lanes. Luckily the drivers suffered only minor injuries and police commented that this could have been a sign of divine intervention given the high speed of the truck. The police said that following the incident, the man had explained that God said the woman was not driving properly and needed to be taken off the road. The pickup driver did not tell police exactly how the woman was driving however. Tests showed that neither the man nor the woman had traces of alcohol or drugs in their systems and the man was later sent for psychiatric evaluation.

Related Content

  • Using ITS to maximise safety and traffic flow for cycling
    January 22, 2013
    Copenhagen, Denmark, has long been known as one of the world’s leading cities for cycling. In some areas of the city, the modal share of bikes has reached a level of as much as 50 %. And on some of the most frequently used bike paths the average daily number of cyclists is close to 30,000. As these numbers continue to rise, new ways of planning and implementing cycling infrastructure are needed. Increasingly, Danish traffic planners are turning to technology as a tool for planning cycling infrastructure. I
  • US road safety remains a cause for concern
    August 9, 2021
    US road safety remains a cause for concern with an increase in casualties.
  • Asphalt milling optimised by 3D controls
    February 20, 2012
    3D machine controls can optimise milling efficiency, Mike Woof reports. More efficient milling and recycling operations can be carried out by using the latest 3D control systems on the market. At the last Trimble Dimensions event in Las Vegas, the advantages of 3D controls for milling operations proved a key topic. The use of 3D control systems can offer huge advantages in milling operations. This technology helps increase productivity as the milling machine will only remove what is required, which also hel
  • Challenges of NMT in Nairobi, Dar es Salaam
    September 13, 2016
    Developing safety for non-motorised transport in East Africa - Shem Oirere writes. Despite increasing national budgetary allocations for the road sector in recent years, governments in East Africa have made very low investments in non-motorised transport (NMT). This is despite the fact that both Kenya and Uganda have recently passed a policy on pedestrian and cycling safety. In Kenya, the County government of Nairobi, the country’s capital, has embraced a NMT policy, while in Uganda the government has passe