Skip to main content

Trial of innovative real-time alerts for wildlife on highways

The Colorado Department of Transportation (CDOT) is testing a first-in-the-USA detection system that alerts drivers in real time of wildlife on highways that cause risk to motorists. The OmniTrax solution from Senstar is based on a volumetric electromagnetic proven sensor, buried approximately one third of a metre underground and about 10 metres from either side of the roadway.
May 2, 2012 Read time: 3 mins
The 5406 Colorado Department of Transportation (CDOT) is testing a first-in-the-USA detection system that alerts drivers in real time of wildlife on highways that cause risk to motorists. The 5408 OmniTrax solution from 5407 Senstar is based on a volumetric electromagnetic proven sensor, buried approximately one third of a metre underground and about 10 metres from either side of the roadway. The sensor detects large animals such as deer or elk, crossing over it, locates the position of the intrusion to within a metre and then activates nearby signs, in order to alert drivers approaching the high risk segment.

The current test installation covers 1.6kms of US 160 between Durango and Bayfield in southwest Colorado (around milepost 96), with six signs on each side. Once an animal is detected, the relevant two signs on each side light up.

“CDOT, in coordination with the Division of Wildlife studied many solutions, evaluating their practicality and economic and environmental feasibility,” explains Kevin Curry, a professional engineer with CDOT. “Fencing, permanent signs and lighting were not quite right for this stretch. We needed ways to minimise the impact to the wildlife’s migration while alerting motorists of their presence. We needed a solution with minimal environmental impact.”

Curry says that alternative detection systems using laser beams, microwaves or infrared technology were considered, but due to the potential for false alarms caused by snow, clouds and even tree branches, Omnitrax was clearly the best option with its high performance rating and low probability of false alarms.

Paul Trouten, national sales manager for Senstar says that Omnitrax is widely used for securing perimeters of strategic facilities, such as airports, military installations, borders, major energy and utilities installations and prisons, around the world.

“CDOT’s pilot project is a new and innovative application for the product,” said Trouten.  He added that the company has received numerous calls of inquiry based on the Colorado application.
Seven speed radar detectors have also been installed to register motorists’ speed both outside and inside the test zone so that drivers’ base speed and reaction speed can be monitored. The radar system will also monitor traffic counts, useful for follow-up analysis of the data by the CDOT’s traffic & safety staff.

The project was awarded a CDOT Research Grant for $150,000 that is going to the 3181 Western Transportation Institute of Bozeman, Montana, to independently evaluate the success of the project.

Related Content

  • Weigh in motion systems aid safety, reduce costs
    February 14, 2012
    Advanced weigh-in-motion (WIM) systems can offer a quick payback time
  • Proven safety barrier installation practices
    June 27, 2013
    Barrier selection criteria should pay close attention to risks for stretches of road as well as regulations. Roadways need to have barriers to provide passive protection for users and to reduce the risk of injury or death in the event of a vehicle leaving the roadway. A wide array of regulations and legislation covers the design and installation of barriers on Europe’s roads. However, there are still a number of loopholes for certain types of roadside protection and further agreement is required to close th
  • Wrong time to end right turns?
    March 15, 2024
    Banning right-hand turns after stopping for a red light is gaining momentum in the US. But debate continues about whether it will result in fewer incidents between vehicles and alternative mobility users. David Arminas reports.
  • Warm mix/cold climates
    February 28, 2012
    MeadWestvaco (MWV) says that its Evotherm warm mix asphalt technology is now approved by the Colorado Department of Transportation (Colorado DOT) for use in statewide paving projects. The warm mix asphalt system can be used in any traditional hot-mix asphalt application, but with significantly lower temperatures required for paving application. This feature is particularly useful in Colorado's high altitude paving projects and has been tested extensively.