Swedish company develops new traffic calming technology

Swedish company Edeva, which was hived off from Prodelox, has successfully tested a new traffic calming method in Linköping Sweden. The technology, called Actibump, monitors traffic approaching a dangerous junction and if cars are exceeding the speed limit a metal trough is activated in the road that cars then bounce over. The trough is six centimetres deep, which the developers say is deep enough for drivers to notice but does not cause any physical damage to either the car or its occupants.
April 24, 2012 Read time: 1 min
RSSSwedish company 5190 Edeva, which was hived off from Prodelox, has successfully tested a new traffic calming method in Linköping Sweden. The technology, called Actibump, monitors traffic approaching a dangerous junction and if cars are exceeding the speed limit a metal trough is activated in the road that cars then bounce over. The trough is six centimetres deep, which the developers say is deep enough for drivers to notice but does not cause any physical damage to either the car or its occupants.

Edeva says Actibump is now ready for a commercial launch and it is in talks about installing the technology in several new locations in 2012.

For more information on companies in this article

Related Content

  • Safety barriers improve highway safety
    July 3, 2012
    Highway safety could yet improve using available technology more widely Safety barriers still offer huge opportunities to improve accident statistics worldwide. There is a wide array of products on the market to suit all types of installation and with a diverse range of solutions for each application. Highway authorities have been installing barriers for many years now and the technology continues to improve, however an analysis of accident statistics shows that barriers offer further potential. Details fr
    Read More
  • INTERMAT launch for Atlas Copco Edge Drill Monitor
    January 6, 2017
    Atlas Copco used INTERMAT to launch the Edge Drill Monitor – an innovative system of measuring shock waves from down-the-hole drilling. Information about the hammer and the bit is displayed graphically in real time, allowing the operator to extract maximum performance and efficiency as geology changes during the drilling process, to maintain the correct degree of flushing and avoid tool breakage.
    Read More
  • INTERMAT launch for Atlas Copco Edge Drill Monitor
    April 16, 2012
    Atlas Copco used INTERMAT to launch the Edge Drill Monitor – an innovative system of measuring shock waves from down-the-hole drilling. Information about the hammer and the bit is displayed graphically in real time, allowing the operator to extract maximum performance and efficiency as geology changes during the drilling process, to maintain the correct degree of flushing and avoid tool breakage.
    Read More
  • Weigh in motion and ANPR techology aid highway protection
    April 10, 2012
    Weigh-in-motion technology manufacturers have been involved in a number of significant highways tolling projects across the world in recent months, while others are looking to become involved in major new initiatives. Guy Woodford reports. The continuing global economic crisis did not prevent UK-based TDC Traffic Systems from recently securing the prized US$2.84million (€2.14million) contract to supply 20 high speed weigh-in-motion (WIM) systems for overweight pre-selection and enforcement in Saudi Arabia
    Read More

Highlighted Content