Skip to main content

Safer speeds required says new report

A new report highlights speeding as a significant factor in a worryingly high percentage of road crashes. According to the report, inappropriate speed is responsible for between 20% and 30% of all road crashes involving fatalities. The report is based on a review of research into the relationship between speed and crash risk and has been produced by the OECD’s International Transport Forum (ITF).
June 18, 2018 Read time: 3 mins
A new report highlights speeding as a significant factor in a worryingly high percentage of road crashes. According to the report, inappropriate speed is responsible for between 20% and 30% of all road crashes involving fatalities. The report is based on a review of research into the relationship between speed and crash risk and has been produced by the OECD’s 1102 International Transport Forum (ITF).


Carried out using data from 10 countries, the report analysed 11 cases. The research used data from countries that have recently changed speed limits or introduced large-scale automatic speed control, such as time-over-distance cameras. The analysis confirmed the very strong relationship between speed and crash risk and that higher speed is associated with increased occurrence and severity of road crashes.

The study also echoes ETSC’s view that the default speed limit where motorised vehicles and vulnerable road users share the same space, such as in residential areas, should be 30km/h.

According to the report, speed has a direct influence on crash occurrence and severity. Its findings suggest that with higher driving speeds, the number of crashes and the crash severity increase disproportionally. With lower speeds the number of crashes and the crash severity decrease. This relationship has been captured in various models. The Nilsson ‘Power Model’ reveals that a 1% increase in average speed results in approximately a 2% increase in injury crash frequency, a 3% increase in severe crash frequency, and a 4% increase in fatal crash frequency.

As a result, reducing speed by a comparatively small figure can greatly reduce the risks of and severity of crashes. Lower driving speeds also benefit quality of life, especially in urban areas as the reduction of speed mitigates air pollution, greenhouse gas emissions, fuel consumption and noise.

All the cases indicated a strong relationship between speed and the number of crashes. A gain in mean speed was accompanied by an increase in the number of crashes and/or injured road users. Conversely, a decrease in mean speed was associated with a decrease in the number of crashes and injured road users. In no cases was a an increase in mean speed accompanied by a decrease in the number of crashes or casualties.

To reduce road trauma, governments need to reduce the speed on roads as well as speed differences between vehicles sharing the same road. Speed limits should be set to Safe System principles. Working towards a Safe System, reasonable speed limits are 30 km/h in built up areas where there is a mix of vulnerable road users and motor vehicle traffic. In other areas with intersections and high risk of side collisions 50km/h is appropriate. On rural roads without a median barrier to reduce the risk of head-on collisions, a speed limit of 70km/h is appropriate. In urban areas, speeds above 50 km/h are not acceptable, with the exception of limited access arterial roads with no interaction with non-motorised traffic. Where motorised vehicles and vulnerable road users share the same space, such as in residential areas, 30km/h is the recommended maximum.

Experience worldwide has proven the effectiveness of automatic speed control systems in reducing speed, and crash frequency. Using measurement of average speed over a section of road is a relatively new measure, but research shows it is effective in reducing speed and contributing to more homogenised traffic flow.

In addition to its impact on road crashes, speed has important impacts on the environment as it is strongly related to the emissions of greenhouse gases (mainly CO2) and of local pollutants (CO, NOx, HC, particulates), as well as to fuel consumption.

For more information on companies in this article

Related Content

  • Fuel savings from road surfaces
    May 23, 2012
    A new study by civil engineers at MIT shows that using stiffer pavements on America’s roads could reduce vehicle fuel consumption by as much as 3%, that could add up to US$15.6 billion at today’s oil prices. This would result in an accompanying annual decrease in CO2 emissions of 46.5 million tonnes. The study, released in a recent peer-reviewed report, is the first to use mathematical modelling rather than roadway experiments to look at the effect of pavement deflection on vehicle fuel consumption across t
  • New non-destructive testing technologies for roads and bridges
    July 11, 2018
    Two new technologies for non-destructive testing offer key benefits, one suiting road surfaces, the other suiting concrete structures - Kristina Smith reports Dynatest has developed a new way to measure and record the state of pavements, using a machine that travels at the same speed as traffic. The Rapid Pavement Tester (Raptor) has been seven years in the making and offers road owners the chance to have comprehensive surveys without the need to disrupt traffic. “People have been wanting to do this for
  • MAD about Vitronic in Germany
    April 30, 2025
    Vitronic has supplied two of its latest sensor columns to the project MAD Urban (Managed Automated Driving for Urban Mobility and Logistics) being set up in Braunschweig (Brunswick).
  • Safer vehicles to cut crashes in Brazil
    November 16, 2015
    Brazil’s road death rate could be reduced with safer vehicles. This has been highlighted by a new research report from the UK’s Transport Research Laboratory (TRL). The report has revealed that 34,000 Brazilian lives could be saved and 350,000 serious injuries prevented by 2030, if UN vehicle safety regulations were adopted and car manufacturers sought to achieve higher ratings in the Latin NCAP crash test programme.