Skip to main content

Mitsubishi tests emergency traffic light power using electric vehicle

Japanese manufacturer Mitsubishi Motors has aided in a pilot study using an electric vehicle to power traffic lights.
March 15, 2012 Read time: 1 min
Japanese manufacturer 3055 Mitsubishi Motors has aided in a pilot study using an electric vehicle to power traffic lights. The trial was carried out in partnership between Mitsubishi and the 2343 National Police Agency. The i-MiEV electric vehicle was modified so that it could be used as a power source for the traffic lights. The electric vehicle was attached to the traffic lights through charging equipment for electric currents. A total of 20 lights were powered for some 120 minutes. The initiative is aimed to prepare for a blackout in the event of a disaster that causes a failure of the electricity grid.

For more information on companies in this article

Related Content

  • Five roads of the future – cutting transport costs
    June 10, 2019
    Advances in road design and construction will deliver cost savings In the past 50 years there have been huge advancements in the automobile industry but the roads we drive on remain nearly unchanged. As cars get smarter so too should the infrastructure that supports them. Our planet is covered in roads. And by 2050 our global network of highways is projected to increase by 60%. Volvo Construction Equipment takes a look at possible technologies for the roads of the future, looking at some innovations
  • Highways England, Kier trial warning airbag
    February 23, 2021
    “Home Safe and Well”* is not just an inflated phrase put out by Highways England to raise awareness of work zone dangers. A large prototype airbag is adding some highly visible emphasis to the agency’s safety focus, reports David Arminas
  • Stop it with SmogStop from Envision SQ
    October 9, 2019
    Canadian company Envision SQ says that it has created a photocatalytic pollution barrier for highways that cuts NOx and VOCs in half
  • Bridge collapse on key I-5 route in Washington State
    June 24, 2013
    The news that a key highway bridge has collapsed in the US comes as gloomy reading for all in the highway sector. When a section of the Interstate 5 Bridge over the Skagit River in Washington failed in May 2013, a number of vehicles were plunged into the river. Luckily no-one was killed in the incident on the route, which is one of the main links between the US and Canada, and the parallel bridge was able to carry traffic, albeit with delays for users.