Minyu shows updated SP series cone crusher

Minyu brought the latest version of a SP cone crusher to INTERMAT. It has been designed to maximise performance by combining an increased speed with a larger crushing chamber, which increases the material capacity and the throughput per hour. The company said that the SP series delivers 30% to 40% more capacity per hour than counterpart spring-type cone crushers. Power transmission from the counter shaft has been increased and better gearing has been introduced, partly thanks to the engineering of the gear
January 6, 2017 Read time: 1 min
RSS5113 Minyu brought the latest version of a SP cone crusher to INTERMAT.

It has been designed to maximise performance by combining an increased speed with a larger crushing chamber, which increases the material capacity and the throughput per hour.

The company said that the SP series delivers 30% to 40% more capacity per hour than counterpart spring-type cone crushers.

Power transmission from the counter shaft has been increased and better gearing has been introduced, partly thanks to the engineering of the gear assembly.

www.minyu.com

Hall: 3 Stand: C136

RSS
View more stories
View more videos

For more information on companies in this article

Related Content

  • JCB adds to Stage IIIB wheeled loader line
    April 19, 2012
    JCB has introduced two additional Stage IIIB-powered wheeled loaders, the 427 and the 437. Replacing the 426 and 436, the loaders use a Cummins QSB engine, which meets the requirements of Stage IIIB without the need for a diesel particulate filter or selective catalytic reduction (SCR). A variable geometry turbocharger improves response, while an optional five-speed powershift transmission with intelligent clutch cut-off system helps to reduce fuel consumption.
    Read More
  • INTERMAT launch for Atlas Copco Edge Drill Monitor
    January 6, 2017
    Atlas Copco used INTERMAT to launch the Edge Drill Monitor – an innovative system of measuring shock waves from down-the-hole drilling. Information about the hammer and the bit is displayed graphically in real time, allowing the operator to extract maximum performance and efficiency as geology changes during the drilling process, to maintain the correct degree of flushing and avoid tool breakage.
    Read More
  • INTERMAT launch for Atlas Copco Edge Drill Monitor
    April 16, 2012
    Atlas Copco used INTERMAT to launch the Edge Drill Monitor – an innovative system of measuring shock waves from down-the-hole drilling. Information about the hammer and the bit is displayed graphically in real time, allowing the operator to extract maximum performance and efficiency as geology changes during the drilling process, to maintain the correct degree of flushing and avoid tool breakage.
    Read More
  • INTERMAT visitors first to see new high flow Bobcat telehandler
    January 6, 2017
    Bobcat has introduced the TL470HF, a high-flow version of its recently launched telehandler. The HF version shares the 4tonne/7m capacities of the standard machine but comes with a 100kW engine (instead of 75kW) and a 190litre/min pump instead of 100litres/min in the standard machine. The result is higher traction power and cycle times that are up to 30% quicker than with the normal flow version with the no-load lift time of less than five seconds. In addition to providing a higher flow rate, the bigg
    Read More

Highlighted Content