Dana Rexroth’s HVT R3 is a hydro-mechanical variable transmission for wheeled loaders with engine outputs of up to 265kW and is the first power split transmission from the joint venture between Dana and Bosch Rexroth.
January 6, 2017
Read time: 1 min
Dana Rexroth HVT3, live at INTERMAT 2012
2254 Dana Rexroth’s HVT R3 is a hydro-mechanical variable transmission for wheeled loaders with engine outputs of up to 265kW and is the first power split transmission from the joint venture between Dana and 2253 Bosch Rexroth
Using a combination of hydrostatic and mechanical drives, the technologically advanced three-range transmission can offer up a fuel saving of up to 20% by delivering a stepless speed range from 0-40km/hr without clutches and without interrupting the drive.
Cleverly, the HVT R3 will allow the operator to preset a maximum travel speed, or preselect a fixed engine rpm and use the transmission’s characteristics to keep the engine working at its most fuel-efficient point.
Launched just before Intermat 2012, Rivard says the company’s new RIV 503 TR202 wide offset wheeled trencher is beneficial to any large scale power cable and pipe laying project, from water and gas pipe installation to power and fibre optic cable laying.
ZF Transmissions used INTERMAT to reveal its cPower continuously variable transmission (CVT) for wheeled loaders up to 210kW. Using experience gained in the agricultural tractor sector, where CVTs have been in use for more than 10 years, ZF’s cPower transmission uses a blend of hydrostatics and mechanical drives to split power throughout the entire working speed range.
ZF Transmissions used INTERMAT to reveal its cPower continuously variable transmission (CVT) for wheeled loaders up to 210kW. Using experience gained in the agricultural tractor sector, where CVTs have been in use for more than 10 years, ZF’s cPower transmission uses a blend of hydrostatics and mechanical drives to split power throughout the entire working speed range.
