Funds released to repair Skagit Rover Bridge in Washington State

Some US$15.6 million in federal emergency funds is being made available to Washington State to help repair the Interstate 5 bridge over the Skagit River, which collapsed on May 23rd 2013. The funds were released by US Transportation Secretary Ray LaHood. A section of the four-lane bridge, located around 100km north of Seattle, collapsed into the water, disrupting travel in both directions. This funding follows $1 million in quick release emergency relief provided the day after the collapse. The Washington
June 19, 2013 Read time: 2 mins
Some US$15.6 million in federal emergency funds is being made available to Washington State to help repair the Interstate 5 bridge over the Skagit River, which collapsed on May 23rd 2013. The funds were released by US Transportation Secretary Ray LaHood.  A section of the four-lane bridge, located around 100km north of Seattle, collapsed into the water, disrupting travel in both directions. This funding follows $1 million in quick release emergency relief provided the day after the collapse. The 914 Washington State Department of Transportation (WSDOT) will use the funds to build a new replacement span. In the interim, WSDOT continues to operate detours and is building a temporary bridge. When the new replacement span is complete, WSDOT will remove the temporary bridge and install the new span. The bridge carries around 71,000 vehicles/day and is a major commercial route between Washington and neighbouring Canada. Approximately 11% of the vehicles are trucks transporting goods between the two countries. A full report into the bridge collapse has yet to be completed but questions remain as to whether the incident was caused by an over-height vehicle that struck a key structural member, causing sufficient damage for the section of the bridge to give way. The bridge also faces questions over the bridge’s long term future. This type of structure is no longer considered suitable for the traffic volumes and types of vehicles it is expected to carry.

For more information on companies in this article

Related Content

  • Fast bridge building in Tennessee
    July 5, 2016
    The Tennessee Department of Transportation (TDOT) recently completed the Fast Fix 8 bridge project in Nashville, with help from a Power Curbers slipformer belonging to Irwin Concrete Construction. TDOT’s goal was to replace eight ageing interstate bridges along Interstate 40 through Nashville using a process called Accelerated Bridge Construction (ABC). This uses fast-paced, around-the-clock work to limit road closures and speed up bridge completion, impacting surrounding communities as little as possibl
    Read More
  • Demolition underway on bridge structure in Cleveland, Ohio
    June 9, 2014
    Demolition work is progressing on track on the old Innerbelt Bridge in the US city of Cleveland and spanning the Cuyahoga River. At present a demolition contractor is breaking up the structure in stages, using cutting gear and cranes to remove portions of the bridge in a phased programme of works. Once the demolition moves to a certain stage in a few months, the contractor will then be able to use explosives to demolish the remaining structure. Four of the truss bridge’s nine spans are being dismantled usi
    Read More
  • I-95 highway collapse in Philadelphia
    June 12, 2023
    A section of the busy I-95 highway has collapsed in Philadelphia
    Read More
  • A new highway for northern Colombia
    July 17, 2023
    The Pamplona-Cúcuta highway is playing an important role for the development of northern Colombia
    Read More

Highlighted Content